Tube Integrated vs Tube Seperates

Forget about SET if worried 30-40 WPC not being enough. Heat will be of some concern, usually more heat with more power. I'd stick to push pull amps, fairly low power. Still like your PL inclinations as you can switch out a variety of power tubes with minimal fuss.

I owned my PL Dialogue Four (self modded with latest PL models Takman resistors and a few other extra mods) at same time as many multiples of price SET amps, I didn't feel deprived with PL. Don't let naysayers of PL throw you off. Not saying there's not other good choices, I've also owned Cary and Conrad Johnson push pulls, its just in same price range your comparing apples to apples.

Quicksilver does get some great reviews. My issue is more cosmetic with them. I really prefer all of the connections to be on one side, and that side should be the back

      Aren't they on the back of the amp?

Aren't they on the back of the amp?

On some of the mono blocks the power is on one end and the input/outputs are on the other end.  I put the power plug in the front and loop the power cord under the amp, looks pretty clean.  

I’m leaning towards seperates right now.

I just don’t think that makes sense for hours of daily use. 

I'm going to change my mind about an integrated and suggest a tube preamp and a solid state amp. If you are burning lots of hours you'll be changing power tubes often. The tubes in a tube pre-amp last a long time. That will get you everything you want. 

If you are burning lots of hours you'll be changing power tubes often. The tubes in a tube pre-amp last a long time.

russ raises an excellent point