Upgrading DC Cables for Linear Power Supply

I have used this below from LPS to Liberty DAC.   There's also a place in England MCRU (Mains Cables R Us), really, that makes them, not too expensive.  Audio Sensibility are very good, bit more expensive, Steven is knowledgable and a good guy to work with

Have bought one DC cable from Ghent Audio for my network switch. Waiting for that to arrive.

Ordering another for M2Tech HiFace Evo supply.

I know this is an older thread, but I am seeking guidance from folks who have compared 'Upgraded' DC Power cables with the factory offerings.  Specifically, I just installed the Limited Edition Teddy Pardo LPS for my Bluesound Node N130, and I am VERY PLEASED with the result- highly recommended.

I had it in my mind that perhaps an alternate DC Power cable from Ghent Audio might improve it a tiny bit further, but I don't see much of anything posted on any forum to encourage me.  To those who have tried it, please offer your thoughts, and also advise if your alternate DC Power cable for your Teddy Pardo LPS is shielded or unshielded.  I have seen mixed recommendations on that.  I appreciate any experience.  Thanks.

@rtilden I made dc cables using Mundorf silver/gold hook up wire with Oyaide DC plugs, I was pleasantly surprised by the improvement over the Uptone (not the upgraded Uptone) DC cables previously used. Using these on JCAT Netcard XE and Sonore OpticalRendu powered via Uptone JS2 lps. I'd estimate DC cables as important as the AC cable one is using on LPS. I also plug all streaming equipment LPS into my BPT 3.5 Sig balanced power conditioner. I've found it important to optimize the entire power chain with all streaming equipment, dc cables can be a weak link.