Subwoofer between speakers?


After reading through a thread relating to the equipment rack between speakers, I assume that the sub between the speakers is also a no-no?

My speaker stands are 24.5" high, and my sub is 24" high, so I was thinking that the sub cabinet being below the mid-range driver might mitigate the detrimental effects to imaging. But I read a reply in the thread that I alluded to which talked about an amp between the speakers having a negative effect on imaging . . . therefore it stands to reason that a big bulky sub cabinet would be about 20 times worse.

I know that ideally I should experiment with placement . . . this is an extreme near-field listening room, and options are limited. I could get it to the outside of my right channel speaker . . . in theory, would that be better than in between?

immatthewj

@immatthewj 

I had the same concern when I setup my subs, but thought I'd try having them between the speakers, so one wouldn't be stuck in a corner, while the other was not and in my case, they sound awesome, sitting between the speakers.

Having said that, my system has all digital source components (no turntable), so having the subs close to the cabinet where the electronics live doesn't seem to be problematic.

sub will not affect the speakers but the sub will probably not sound best in the center of the wall.  typically they sound best near corners.  follow your sub's instruction manual for best positioning.  

+1 @soix @mike_in_nc 

It is so room dependent, that in a way, the question is ill formed. There are room mode calculators -- look up amroc, e.g. -- that can help. But ultimately, rooms have so many idiosyncrasies that after getting some "rules of thumb" to at least have a starting point, it will come down to whether or not you have a trial and error method that is systematic enough to keep you from working on this for the next year.

@hilde45 ....so one will default to the 'on the knees, outdoor chess' means of sub sites.....corners, wall sites.

One will have to apply a certain amount of exertion to attain a 'base level' of response (and Yes, pun intended...).

Little tweaks Will follow...yes...😏

Note to nerds:  Code a 'ware similar to REW that 'scans' the 'raw space', crunches awhile, and suggests placements for previously 'auditioned' drivers used in the scan....

It will cost whatever, but the audio community will build an off-ramp to your door. ;)

Running the app will likely bake your laptop...*L*

I'm kidding....but only slightly....;)

Our 'spaces' vary so much, and what with what's within them, that 'AI Assistance' seems inevitable...or desirable....*G*

"Alexa....Fix my audio issues...."

*Alexa explodes* ;