Tone arm plug in RCA cable?

If the OP wants to replace the Cable used for the PIB - 1, the method when used will add one more set of connections and disruption in the signal path.

Causing this condition is usually one that is avoided and attempts are made to keep the connections to the minimum required.

If this is the only option the OP is considering, a Pure Copper Zavfino DIN Plug and the Chassis Mount  Pure Copper WBT reduced eddy RCA's will be a good start for the connections.

These parts 'could' be attached to the box, which will remove the need for the length of cable to be utilised. The additional Space that may be required under the TT to achieve this would need to be addressed.

A length of Cable with PC Triple C or D.U.C.C Wire will be a cable worth experiencing, if the Cable has to remain used with the box, either of these Cables will most likely be kept and expanded on in use as umbilical's at other interfaces.       

Pindac, You wrote, "If the OP wants to replace the Cable used for the PIB - 1, the method when used will add one more set of connections and disruption in the signal path."  I beg to differ.  He is already using the box, so changing the wires between the DIN plug and the box will not add physical connectors in the signal path. That will not change.  However, by eliminating the box interface, then he can reduce the existing number of physical connections in the signal path.

I gather you have strong opinions on what kind of wire sounds best.  So do many of us, but I think getting rid of the box is the main thing,

@holmz  : " I have a tone arm with a connector that plugs into the bottom of the arm.."

Which tonearm and which kind of connector it has? for what you posted  the tonearm output connector is a DIN Pin5.

@imhififan ​​​​​@yogiboy  already gave the solution.

" Is there any meaningful sonic advantage in going direct from DIN to phono stage? "

Absolutely, you need to go directly to the phono stage with nothing in between the DIN PIN 5 output connector and the input at PS other that the IC cable that those two gentlemans already posted and gave you the link ! ? ? !!

R.

@lewm makes no sense to follow stupid posts but is up to you.

R.

@holmz : Please follow the @lewm and other gentleman advise. You don’t need the PIB..

 

" I need to try a different search engine. "

 

I think not, what you need is to follow trusty audiophiles that give you " solutions on hand " and stop to follow stupid posts.

 

R.

I can only work with what I have, so if it looks stupid I can only offer and apology as that is as good as it gets. But as I asking,  it appears that I am open to receiving trustworthy advice.

The PIB is as @imhififan posted.

I’ll try an older DIN to RCA I have laying around, and see how it sounds, and then go from there.