Audio Research Ref 75 SE: Replace 20A IEC inlet with 15A


Has anyone successfully replaced the 20A IEC inlet with a 15A to use a good 15A power cord?  I am currently using 2 Voodoo adapters: a 20A female to 15A male + a right-angle 15A adapter due to the depth of the amp causing it to come up against the wall.  Less than ideal, but works fine and sounds great.

Since the amp doesn't require 20A circuit it would be nice to replace the 20A inlet on the amp with a good quality 15A inlet for a direct connection to the power cord.

If anyone has done this, which 15A inlet did you use?  Does it fit well in the amp's cutout and were you able to use the existing screw on connectors to fasten the internal wires or did you have to solder them?

 

eugene81

Well, I hate to disagree, but I must. The 75SE would very likely be just fine with a 15 amp IEC. You are correct that the size of the IEC-in this scenario-has nothing to do with the amps being delivered or the rating of the switch in the panel box. Any decently qualified tech and whole lot of amateur techs could do this for you. I hate to say it but I think ARC just thinks it is impressive to basically mandate use of a 20 amp IEC when a 15 would supply equivalent current and voltage given the circuit. The size of the IEC receptacle and plug is purely cosmetic. ARC seems to think the 20 amp IEC also provides for  tighter fit but that has not been my experience at all. 

@lak Yup, agreed. Just wanted to check here to see if anyone found a 15A inlet that’s easy to swap in terms of dimensions and internal connectors. It would be a matter of turning a few screws with no modification to the chassis.

Well, turns out changing the 15A female connector on my power cord is even easier. No heat shrink, all screw crimped to 3 conductors, so I will be buying a 20A female connector and changing it myself.

Case closed.

@russ69 I don't see how that would cause a future owner a problem unless they only have 20A wall socket. 

Eugene, I'm not a home wiring or amp design expert. Some mega amps have gone to 20 amp service requirement. Although I'm very unlikely to play at levels that require 20 amps, the amp manufacturer thinks that they need to wire the amp for a full 20 amp draw. Your solution of replacing the 15 amp connector with a 20 amp connector is a good solution with me guessing the power cable is over sized for 15amp usage. 

@eugene81

 Well, turns out changing the 15A female connector on my power cord is even easier. No heat shrink, all screw crimped to 3 conductors, so I will be buying a 20A female connector and changing it myself.

Case closed

Fully resolved outcome!

This amplifier  power dissipation is 500 watts maximum and 230 watts at idle. Only 4 KT 150 output tubes  and 2 6H30 tubes. Power storage is 520 joules. Pure curiosity,  why does it have a 20 amp cable requirement?  The circuit would never come close to this amperage. I wonder what the  ARC 20 amp  implementation  rationale is. Interesting. 

Charles