Your short speaker cable experiences


I'm going to compare my present speaker cables with the shortest runs I can find -- perhaps as short as 2.5 feet from mono block to speaker.

I'm curious if anyone tried comparing their longer speaker cables against short runs of other ones and whether it made a difference or not. 

What changed? Did it cause you to reposition things?

Happy to hear stories. No trolling about "wire is wire," please. 

128x128hilde45

I am very skeptical that 5 feet will make a difference. 

But I may be wrong. 

I mentioned the Neotech because it's something I would like to try.

You might also look into VHAudio bulk wire offerings (wondering if their much less expensive interconnect cable would work well as short speaker cable)?

Hoping that you will experiment with the better version of the Neotech 22 gauge solid core copper, just to hear your feedback.

Single runs of smaller gauge solid core copper speaker cable can (most likely will) offer somewhat less tight bass, which I prefer, but not reduced bass as many suspect/think/believe (quite the opposite form my experience).

Years ago when I ran 12' runs of the tiny OTA between an Audio Silver Night DH/SET 300B amp and Reynaud Twins MkII two members "here" who listened to the setup asked if I had a sub hidden under the bentwood settee located between the speakers.

The Audion was SS rectified and I suspect that the small gauge OTA reduced the damping factor to some degree with the 12' runs.

One thought he busted me (he stayed the weekend) when he found a wooden box tucked way back under the settee, but it was a wooden crate containing a 3 liter bottle of Italian wine that I was storing for an upcoming patio party.

 

DeKay

 

I run my speakers in bi-amped mode, with one mono block amp behind each speaker. The speaker cable is 8'' long with bare ends. And a second mono block amp underneath each speaker with a 12'' long speaker cable again with bare ends. There was a very, very, very minuscule difference in bass impact compared to the 8' long cables again with bare ends I was previously using. Also, all cables are DIY the same type/brand 14AWG. To my knowledge, speaker cables should always be as short as possible even if there is no audible differences.

Mike

My experiment is going to be with Cardas 101 bulk wire, 14 awg. I will try it at 3' and then try bi-wiring with two 3' runs. 

I run three subs, so I'll turn those off during the comparisons. They take care of bass issues pretty nicely, so I will be listening in other regions of the audio spectrum for differences.