Linlai E 6sn7 tubes


I just placed an order for a pair of these for my Aric Audio Motherlode II.  I’ve been chatting with a fellow that runs the E 6sn7 in his Don Sachs pre. He loves them, He says they make his NOS tubes sound thin and lifeless.  
    It will be a couple weeks until I receive them,and I was curious if anyone out in Agon land has tried these,and what are your impressions?   
Thanks in advance,

    Ray

rocray
Hi All
I wish to seek your advise. Do the  E 6sn7 Linlai tubes fit the sockets as in it is fully seated in the Schiit Freya+ without any gaps
I was excited and went to purchase the LinlaiE6sn7. Brought my Freya + amp along. But the  salesperson could not fit the Linlais into the sockets fully. There was a slight gap between the socket and base of the tube,  a little of the pins could be seen.  This was only two tubes at the gain stage.  The tubes were not fully seated on the sockets. I left the shop empty handed. Darn. Any one managed to fit the E Linlai 6sn7 fully into the Freya+ sockets? If you have, pl do let me know how as I really like these tubes. Thanks a lot.

No, the Linlai Elites will need socket savers to fit in the Freya+. I’m using the Amptata’s from Amazon. 

Best value in high-end 6SN7 tubes. I had to replace an insanely-expensive pair of NOS Brimar CV-181 with the LinLai Elite and the new tubes are on par with the other tubes which cost 4x as much. Buying through Rachel at Grant Fidelity is always a great experience. 

Once again, I’d like to send a thanks out to @decooney for the suggestion of tapping to loosen up the cathode material inside the tubes. I had to repeat this process three times. I have had the Linlai’s back in for about 8 hours today with no tube rush or any other nasties.  Also,looks like my second pair will be in my possession on Monday.  I will give those a good burn in once they arrive. 
 

     Ray