Perimeter Ring Clamps: Yay?, Nay?, Sources??

What I need, is for someone who has a Perimeter Ring Clamp to come visit, mess/listen, decide!

Plainfield, nj

07062

Elliott, I was looking at my TT101 with your quest in mind. As you know, the two platters present the same problem for fitting a perimeter ring. There is very little margin for error. In fact I can think of no “off the shelf” ring that would fit. Certainly my Kenwood ring is not even close. So, if you do invite someone to bring his ring to fit your TT81, I’d advise you to be sure in advance that his ring has a hope of fitting.

you are right, and I am having a hard time believing Wayne that one of his will work on my TT81.

lewm,

I am going slowly thru halcro's old thread about JVC TT101. from 2011.

JP Jones, ought to be John Paul Jones, i.e. DEEP SIX the Beasts!

Six Leagues Under the Sea is where they belong.

What a masochistic club, you only need merge with Jaguar V12 owners to be completely happy.

There must be a survivor mentality, however short lived.

I don’t understand.

First, JP never suggested dumping Victor DD turntables. Second, in my experience the TT101 has been 100% reliable since JP repaired it. Or do you advocate dumping them because you may not be able to fit a ring?