Low Frequency Rumble from TT between songs


I'm sure it's in the songs too but I'm getting low frequency rumble now that I've switched from Harbeth 30.1s to some large base reflex studio monitors. Between songs and on the lead out groove I'm getting a rumble at mid to high volume. Is that an isolation issue or something else. Table on a wall shelf, about six feet from the BACK of the left speaker, so I'm not understanding why this would happen.

dhcod

Do you hear the rumble just turning on the VPI player (on high volume), or only when the stylus is in the record groove?

missioncoonery

1,106 posts

Have you considered a dac?

Your disdain for analog is almost as annoying as your frequent childish rants about a certain speaker company.  Remember which forum you find yourself in.

Give it a break......

Do you hear the rumble just turning on the VPI player (on high volume), or only when the stylus is in the record groove?

No. Only when the needle is on the surface of the LP.

Which feet are you using on the Aries?

Which wall shelf? Make sure your wall shelf platform is level and all contact points have even pressure. If all is well, a simple but not inexpensive solution is a Townshend component platform, if it’ll fit on your wall shelf. Another plus, you can always use it under another component in your system.