Have you ever solved a high end audio issue using non-audio technology? Or, visa versa?


Sometimes we just have to be creative to fix a problem.  Our "bag of tricks" may go well beyond the usual "audiophile grade" tools of the trade to produce a positive result.

Here's one:

Years ago, I acquired a little British sports car.  This, itself is an unusual story.  I'm a performance car enthusiast with a 835HP vehicle is parked in my garage.  

At any rate, the little 4-cylinder "tractor motor" had solid lifters that sounded like a Singer sewing machinegoing down the road above 3,000 RPM.  It distracted from the driving experience.  I was thinking how nice it would be to quiet them down a little.

Then I remembered the can of Acoustical Magic material I had in the basement.  For those unfamilar with this material, it's used to dampen the vibration/resonance of turntable platters.  I pulled the aluminum valve cover, cleaned and degreased it thoroughly, then applied a generous portion of Acoustical Magic.  After a little curing in the oven and allowing it to set for 24 hours, the valve cover was reattached.

If I had it do over again, I would have measured before/after with a spectrum analyzer. But, my best guesstimate is that there was a 6-9db drop in the tapping sound, and I could hear the sounds around me while cruising.  The driving experience improved exponentially.  Thanks to Acoustical Magic for a cheap, effective solution to my "acoustical" problem.

I have to admit that a year later the true "hot rodder" in me required that I add a turbo to the little engine.  The sound of the off-throttle blow off valve is music to my ears.  And, driving something resembling a real sports car, as opposed to a British commuter car was a plus.

128x128waytoomuchstuff

Using carpet squares under my tube amps and preamp made quite an audible difference. 

@clearthinker It was my room. That photo was from an experimental phase. Some of you might know @brownsfan . He and I corresponded for months. He discovered that when a cd rack was placed in a way that diverted some of the direct sound, it resulted in significant improvements in soundstage accuracy and a sense of spaciousness. I didn’t have CD racks but went and bought some boards, had them cut, and tried them in various combinations. He and I tested this extensively in my room -- with REW and small movements of the boards -- forward and back, different angles, heights. Listening, measuring, moving, repeating.

I suppose could take umbrage at your comment, but I'd rather think that you and I are different in how we approach audio. I like to listen with my eyes closed, too, but during the early phases of setup and getting the sound right, I like to keep them wide open.