Troubleshooting Fosage Signature phono amp.

You're absolutely right, I completely blanked on the SUT / design. I recalled the Fosgate being very noisy/microphonic on the MC setting, so I ended up getting an EAR MC3 SUT to pair it with.

So you're right, something else might be causing the issue electronically beyond the toggle switch, but looking into the switch might be a good first start.

Best of luck in addressing it!

Microphonics seem to go with certain tube (DHT) designs. Turns out that I generally love the sound of such tubes. They say isolation is the key, but I have found that to be quite a challenge when addressing the problem. In some cases, the answer turned out to be part of the problem! (I wonder if those copper tube sleeves might not be helping).

  I did not get a good look at the circuit board, but it likely has those snap in connections that I hate so much. They can seem to be solid with problems not seen. Maybe you can use De-oxit on those connections to see if that has an effect on the problem. Switching back and forth, can in rare cases, have the just vibration from the mechanical switch action to temporarily remake a connection. I doubt that it is the switch itself, but something out there hanging by a thread (electronically) that is making and breaking contact. 

 BTW, the switch itself is likely sealed and cannot be cleaned with De-oxit. That is also to say that oils and other contaminants won't be seeping in over time. 

As much as I loved the sound of the Fosgate, it was noisy so I moved on. I hope you can figure out your issue.

"(I wonder if those copper tube sleeves might not be helping)."

4krowme-insight appreciated. I use the Foz WITHOUT the tube shields- never noticed them preventing extraneous noise.

Having a Sunday afternoon free, I poked around and disconnected/reinserted that white   cable that leads to the output jack. Not having pulled the board, I believe it interfaces with that switch on deck?

Since then, the Foz is playing fine. Something going on- perhaps a break in continuity and that move temporarily  "bridges " the open?

Also, I redressed that red/black cable on the same  channel. The wires had just 1 twist. Doing so  completely eliminated a slight hum that could be heard at 12:00 and higher. The Foz is nice and quiet now from the listening position-WIN!

"As much as I loved the sound of the Fosgate, it was noisy so I moved on."

Ozzy62-

Yeah, I get it. I believe it's the all tube topology which is a double edged sword-fantastic sonics, but depending on music genre and volume level, tube hiss will always be present to some degree-even with "premium"  tubes.

The unit  build is el cheapo! I'm not sure if it's a MIC product, or where it's  built. 

The sound presentation however, to my ears isn't bested by some of the usual tubed suspects up to the $4-5k range. They are quieter,  but only when the music stops. Had several side by side, then heard by the S.O. and her girlfriends. They heard the Foz as most convincing, as my ears do.

tube phonostages hiss and microphonic, because tubes cannot be that of a high gain especially for LOMC carts. also tube phonostages LOVE to EAT tubes FAST so checking tubes more frequent with tube tester than in poweramp is recommended.