Moving Magnet & Moving Coil Cartridges Question...


Sorry to ask this but I have not found a definitive answer yet.  I have a turntable I got a couple years ago and I installed a Shure Moving Coil Cartridge.  At the time I had a pre-amp that would support it.  I am looking at replacing that pre-amp with an older unit that matches the rest of me Carver equipment but it does not support MC.  If I get an external amp for this situation, which I see online, can I use it in the regular turntable input in the pre-amp?  I believe I am seeing no but again..nothing that seems definitive.  I may have to replace my MC cart with a different one that the pre-amp supports...

Thanks in advance for your help on this. 

 

Bill

smtcobra2

Shure never made a moving coil cartridge. They are all moving magnet. Big difference! What is the model number of your Shure?

RIAA Equalization of a phono cartridge’s signal (boost bass/cut highs) must occur somewhere, and a phono cartridge’s signal strength must also get boosted UP to Line Level strength, then thru a volume control then to the amp.

Unless specifically noted as MC, built-in Phono Stages provide RIAA EQ. They only accept ’sufficiently strong’ Phono signals of two types:

1. MM Moving Magnet typical signal strength

2. HIGH OUTPUT MC Moving Coil, signal strong enough that it does NOT need any pre-preamplification.

IF you ever get a LOW OUTPUT Moving Coil Cartridge, those signals need pre-preamplification, to get up to the strength of MM or High Output MC. After that, RIAA Equalization and normal preamplification up to Line Level must occur.

Step-Up-Transformers (SUT) are made to increase the strength of LOW OUTPUT Moving Coil up to the strength of MM or MC High Output. That pre-preamplified signal then needs to go thru the RIAA Equalizarion process (somewhere). The SUT can be a separate device, OR, it can be incorporated in a Preamp, always labeled Phono MC. Either a separate Phono MC input jack, or a single jack that can be ’switched’ to either MM or MC. The switch can be in the front or back of a unit.

Note: some preamps or receivers have a ’Phono/Aux’ input. They are not true MM Phono inputs providing the needed RIAA Equalization. They are simply NAMED Phono for convenience, they require external prior Phono processing elsewhere.

Hi. Thanks for the response. I thought that would be the answer. As far as the MM vrs MC thing I guess I look like a complete A$$. The worst is that I bought this other pre-amp because I thought the one I had did not support the new cartridge. So I really suck. Thanks for setting me straight.

So my old M91ED and the new M97XE are both Moving Magnet.  Figures. 

 

Thanks for all your guys help.