Question about assembling my own DIY AC Cable

I also like SonarQuest rhodium plated connectors. Good quality and they sound good.

Remember that the green gets connected at both ends, but the shield connects to the green wire only at the wall.

PS - I am not a fan of Rhodium plating.  It's not that conductive and it's too hard of a surface which makes it harder to grip well. If you must do rhodium plated plugs consider hospital grade outlets to ensure a tight fit.

@carlsbad  said:

Put the red cable and black cable in the hot pins and the green to the neutral.  The connectors are probably marked.  

Me thinks you need to reconsider your thinking...

I would terminate the black banded conductors on the neutral pin terminal of the male plug, the red banded conductors on the Hot pin terminal, and the green banded conductors on the ground pin terminal. I would only connect the shield drain wire to the ground terminal on the male plug. Float the drain wire on the female IEC connector end...

YARBO SP-1100PW Triple Shielded Power Cable OCC

Jim

.

@rayleigh ,

Looking at the specs of the IEC connector:

Conductor: Pure Copper

Pure copper is a soft metal and does not have any memory retention properties. Copper contacts of the IEC will not hold the female contacts tightly against the IEC inlet male plug blades... A poor connection can causes micro arcing and cause harmonic distortion. I would look for a better IEC connector.

What wire gauge equivalent is the Hot and neutral conductors?

The individual insulated conductors look like solid core silver plated copper wire. Yes? That’s good...

What piece of equipment will the cord be connected to? Analog? Digital?

.

The specific answer to your question is that with Furutech plugs and IECs, the connector consist of a clamp with center set screw, as shown below.  Therefore, best practice is to split the wire so that half goes into each side of the clamp.

@audphile1 made a good suggestion to coat the exposed conductors contact enhancer before clamping.