Phono preamp with best mid bass

It's the Clearaudio Ebony Wood MM. The only setting the MF has is either MM or MC. Honestly I just plugged in the Triton and just played it with the stock settings out of the box. I plan on seeing if there is some fine tuning yet to be done as the unit is pretty flexible. Below are the different settings available on the Rogue unit: 

"Four different gain levels are available (43dB, 55dB, 60dB, 70dB), plus 20, 30, 100, 300, 1K, 47k, 75K, 100K Ohm loading options and 0, 47, 150, 470,1K Picofared loading options. "

You should be good with 43db gain and 47k load with that cartridge. The other pf settings are for capacitance. I would keep that at default or zero. 

Ok guys!!! So 0 static, hum or any other BS up until NOW! When I touch the tone arm static, touch any damn thing high static. Checked grounds all good. Floated the ground on the Triton. Thought it helped for a minute but no same thing. I can actually see the tubes on my tube amp flicker when I touch the tone arm or any of the wires. Pissed! Lol. Gonna screw with it tomorrow but opinions much appreciated! 

I was very happy with the sound then poof! Lol. Think I will drag the damn dresser out check all connections which Im pretty sure are good. Came out of no where . Dead quiet before if that gives any indication. Phono pre got an internal deal? I really dunno? 

Low humidity? Dry air in the room? Do you use zerostat or anything else that helps dissipate static? Try grounding yourself before you touch the turntable arm. Lastly, try plugging the table back into the MF built in phono and see if issues persist.