Phono preamp with best mid bass

Ok guys!!! So 0 static, hum or any other BS up until NOW! When I touch the tone arm static, touch any damn thing high static. Checked grounds all good. Floated the ground on the Triton. Thought it helped for a minute but no same thing. I can actually see the tubes on my tube amp flicker when I touch the tone arm or any of the wires. Pissed! Lol. Gonna screw with it tomorrow but opinions much appreciated! 

I was very happy with the sound then poof! Lol. Think I will drag the damn dresser out check all connections which Im pretty sure are good. Came out of no where . Dead quiet before if that gives any indication. Phono pre got an internal deal? I really dunno? 

Low humidity? Dry air in the room? Do you use zerostat or anything else that helps dissipate static? Try grounding yourself before you touch the turntable arm. Lastly, try plugging the table back into the MF built in phono and see if issues persist. 

Rather than focusing on the phono stage, you should be looking more closely at your table/arm/cartridge combination.  Phono stages should be "flat" to the RIAA Equalization" response.  Table qualities; arm mass, damping and geometry; and cartridge have a MUCH GREATER IMPACT on quality.  "Silk purse / Sow's ear" situation.  The phono stage can't fix problems or deficiencies with the table/arm/cartridge.

Well while not totl my Tt setup was eclipsing my phono stage. The Rogue is great and I fixed my hum static issue I was having last night. For now. I’m a total newb in vinyl basically. I’m digging it more than my digital setup which is descent.