Advice on a tube tester


Well I just got kicked off Facebook for the weekend so I'll probably be active here.  Not sure if that is a plus or a minus for Audiogon.  😎

I'm looking to buy my first tube tester.  I want to be able to identify bad tubes, verify readings on "NOS" or "used, measures like new" in tubes I buy, and I need to sell off a bunch of tubes and I'd like to be able to test them before I sell them.  Selling a bad tube, refunding the money, leaves me out shipping, a lot of work and 3 good tubes in limbo. 

So I'm looking at a B&K 707/747 or a hickok 539A or similar, mostly just based on what I see that fits my needs and seems to be $500 or less.  I see tested and calibrated tube testers for $1500 on ebay but I think I can get by for a lot less.

Tubes I have to test are 6l6 series, EL84, OA3/4, 6922, WE396, KT88 and maybe a few others.  it would be nice to test 300B/350B tubes but I think most testers doen't do that. 

So I'd appreciate guidance from people who have been testing tubes for a while.

Thanks,

Jerry

128x128carlsbad

@oddiofyl Thanks for the story.  I'm starting to play in NOS tubes too.  I have a bunch of not necessarily new but old stock voltage regulators I'd like to sort.  

I've looked at the Toolshed amps and they look nice.

Whick hickok did you choose?  

thanks,

Jerry

Hi,

All good testers you mentioned. I have had a TV-7b and it was a fine well built unit. Currently using a BK 707 and love it. Design is especially great when testing multiple 9 pin miniatures such as ECC83, ECC82, and ECC81 etc. Have used a BK747 and would be my last choice of the lot.
Calibration of these units can be done yourself and is not terribly difficult. There is a wealth of information out there. I did both my TV7 and BK707. Try to find one that is in good physical condition that shows light use. Heavily used ones can have sockets that make poor contact and it becomes a lot of work to replace them, although it is doable. Found my minty BK 707 ON FB marketplace locally for $200 and calibrated it myself. Does all the audio tubes and was these guys were made toward the end of the tube era.

Rob

@thermionicemission 

Rob,

Very useful post.  I'm finding a lot of testers don't do the 9 pin minatures that were introduced with color TV so they are relatively new.  For the TV-7 you need the D/U.  for the 752 you need the A to test 9 pins. for the 539 you need the C.  the 539 tests each triode seperately so you have to test them twice.  It does a lot of testing but maybe more than I need.  The B&K 707 attracted my attention early and I'm glad to hear your views--from someone actualy using one he calibrated himself.  Fully agree on replacing sockets, can do it but do I want to?  

I've been up and down the scale on these testers a few times.  Right now I'm leaning toward the 707 or the TV-7D...probalby whichever one I find first in good condition at a reasonable price.  

If after using the tester a while I want more data, I can buy a high end Hickok then.

Jerry

I have a Hickok 800 , it’s perfect for screening tubes and preventing your amp from being a “tube tester”.   It’s more than adequate and fairly accurate.   If I were buying and selling tubes I would get a 539 or military type Hickok

I just bought a new Amplitrex.  It is easy enough to use and "computer mode" greatly enhances the set of functions.  Not cheap but well worth the money.  That said, I sell a lot of tubes and this unit is sort of essential for me to be able to communicate with Jac Music.