Dedicated Line - Things to consider


Hey all,

So…as far as building my system is concerned, I’m pretty much in a good spot for now with the components and cables. I can say I’m satisfied with the sound. But, as we all know, system building isn’t an action that can ever be completed, it’s a state we’re constantly in.

Right now I have few finishing touches left. 
1. Run a dedicated line 
2. Improve room acoustics

Wanted to solicit some thoughts on running a dedicated line. 
First of all, is it a worthy addition? What are the deciding factors? I realize all the appliances in the house 💩 into the power line, and I use a power conditioner for the source components. Amp is plugged directly into the wall. 
Here’s what I have in mind if I’m to go ahead and run a dedicated line - 14 awg solid copper wiring - any particular brand? 20A or 15A circuit? Is it worth running one for the amp and one for source components? Or is using one duplex outlet on a dedicated line sufficient to cover amp and source components? 

Would appreciate any thoughts based on experience and lessons learned…what would you do differently if you were to do it again? What improvements should I be expecting?

 

Thanks in advance for sharing your thoughts!

128x128audphile1

@immatthewj please let us know what you’ve heard as a result of the test when you get around to it

@audphile1  , since I can no longer edit my reply, I'll clarify a couple of things with a new reply.  This is not a biggy, but I previously referred to the "lateral & horizontal size of my soundstage" and I meant the lateral and vertical size.  When referring to the power cord of my SA10, I think I said a two blade outlet, and what I was actually referring to was the two blade INLET for the removable power cord on the SA10.  I mentioned this because, going to some of the threads I pasted above, the  3rd wire, the ground, was the point of some of the discussion.

I never could understand why you would need to separate the wires when they all come together for at least some distance to go into the main panel or sub panel. 

@invalid  , I won't attempt an answer; there are many  things including this related to electricity that I do not understand.  This might be worth asking JEA about.  A possible theory is maybe RF is like food poisoning.  A little bit is not good but a lot can kill you.  Remember, I did say "maybe." 

 

We have two breaker boxes, the original, which is fully loaded with breakers, and a second added later that is closer to the street that has a few breakers in it. I ran 125 feet of 8-gauge multi-strand from the stereo location in the living room to that panel with a 20 amp breaker and put a 20/30 amp outlet on it inside my entertainment center. (My surge protector has a 20/30 amp plug.)

From the 20/30 amp outlet I ran the 8-gauge to a pair of hospital-grade outlets located just outside the entertainment center. The run is continuous and there are NO breaks in the lines between the various outlets. There is also a big ferrite bead over the wire where it comes out of the panel. Even the hospital grade outlets accepted the 8-gauge wire without problem.

This had the effect of removing "high-end hash" from my Yamaha Universal Player. It did less for my Oppo95, and I attribute this to a better power supply in the Oppo.

It's just semantics, but a lot of these posts would be easier to read if they were worded a little differently. Most professionals don't think of wiring as originating at an outlet in a room and going to the electrical panel, quite the opposite.