Please help with setting up a streaming system


Hi guys and gals,

I would like to start streaming some high res and cd quality music. I am very computer illiterate so please take it easy on me. I would like to set something up fairly easy to use and not spend more than 2k. I currently have an older PS Audio PWD 2  with just the bridge card and the PWT memory player going to PrimaLuna mono blocks and pre amp. I would like to use my dac if it is still a viable solution because I really like the sound when the recording is decent. Can someone please offer some direction and experience with where to start?

Thanks in advance for any advice and suggestions!

 

justinm

I finally got the N100H hooked up and connected with a cheap Wi-Fi extender temporarily until I can run a cat7 cable from the router. Thank you so much for all your suggestions, I am really blown away with the sound quality. I was expecting it to be as good as an average sounding cd but so far it has far surpassed all but the best recorded cds. The Aurender sounds a lot closer to my VPI prime and way more analogue than than the dac and transport to my ears. I know I won’t stop spinning vinyl anytime soon but this is way more convenient without the clicks and pops of poor pressings. I’m very happy I went with this and have no regrets so far.

OP,

 

Excellent. Happy to hear… and it only gets better from where you are!

@justinm : Let me understand what you’re doing… You plugged a wifi extender in somewhere close to the streamer, then you plugged the streamer into the extender to provide a wired signal from your network (presumably with an Ethernet cable?). What’s the process to link the extender to your network? I just switched from cable internet, with a modem and router, to a Verizon 5G gateway. It’s been working well for providing internet access, but I’m not sure how to incorporate that to use for streaming. Sorry if this is basic, I’m not a computer guy 🤷🏻‍♂️

Hi krelldreams,

yes that is correct I used a TP-Link AC1900 Wi-Fi extender available on Amazon prime to get up an running before I pull a run of cat8 from my router on the other side of the house. We use cox cable for our internet provider and after downloading the Wi-Fi extender app and going through a couple quick steps and running a 15’ cat8 cable to the Aurender it seemed to work. The Wi-Fi extender is about 40’ from the router and 5’ from the Aurender. Trust me when I say I am very computer illiterate and have put off streaming for the last 5yrs because of this. I plan on pulling a 100’ run of cat8 through the crawl space today which I’m not looking forward to but want to be sure of the most stable signal possible. The Wi-Fi extender is actually working flawlessly at this time but I’m off this weekend and might as well getter dun👍

I, and I assume many others here, would LOVE to hear your impressions of any differences you hear between running direct from your router and using the extender.  This would be MOST VALUABLE information as so few people here have done both.  Thanks in advance!