Denafrips FPGA Firmware Update


In case there are any Denafrips DAC owners out there that are not aware of the FPGA Firmware Update, here's the link:

I did the update on my Ares II earlier today and am currently enjoying the results.  It is definitely an improvement without question.

mceljo

@dman1974 and @liangx5 - thank you both for the responses. I have the Pontus ii connected to an Hermes via I2S and am enjoying the new FW. I do not find the new FW to be too bright or harsh. My system is very relaxed and neutral and think the additional detail and expanded soundstage sounds great. I’m going to wait until the new FW is released and try it next but I have to say, I’m enjoying the latest upgrade. I know it is system dependent and can understand why many are going back to the earlier FW. 

Slightly off topic and sorry for tangentially hijacking the thread, but how would you all suggest I stream direct from a tablet to the Ares2? Any usb c to usb b adapters you’d recommend? Or should I keep streaming Tidal via wifi through my Oppo 105 into the Ares?

I tried getting the firmware update and my pc crapped out on me, and after several more attempts I couldn't do it. I sent them a picture of the chip, tried following the directions but it wouldn't take. Anyone else out there have a problem?

@grh1958 - Safe to assume that your post isn't representative of the order that you tried things?  You went through the official process of sending Vinshine a picture of your chip and then attempted to follow the instructions upon their reply with your computer having issues?  Just clarifying so that others with a similar experience can know for sure.

@mceljo while trying to install my firmware (a different issue) it just added to my frustrations while I was trying to install the firmware. Fortunately I have a couple of spare PC's. Whenever I try diy on any of my electronics it is very difficult for me at best, and often turns to shit. I don't know why the firmware installation didn't work but I'm glad that I at least brick didn't my Denafrips ares. The firmware version that i have is 3.06, so it has missed a couple of firmware updates since this new one came out, I'm not sure if I would need to install each update one at a time. Anyway thanks for asking and I'm going to try it again when my nerves calm down and hope for the best. Thanks for asking.