2. headphones
  3. 184621-75799

Certain frequencies hurt

Recently, due to certain frequencies coming across excessively loud and hurting my ears I've decided to run headphones (Sennheiser HD 800 or Hifiman HE 6se) instead of speakers through my power amps speaker taps. Then I ran across this yesterday:

"I’ll point out you need to be careful with Tube based speaker amps, they are designed to drive a specific impedance, and you’d want to match that with either a resistor in parallel with the headphones or a transformer to impedance match.
It’s also the case that more powerful tube speaker amps will self destruct/blow a fuse if a load is not connected to the terminals, because without the reflected impedance the circuit will draw too much current."

So will running headphones through my Audio Research Ref 75 possibly cause harm to the amp or preamp (both tubes)? The sound is sublime and it causes me no pain. Is this (speaker) set-up overkill for these headphones?

 

mewsickbuff
carlsbad2's avatar
carlsbad2
1,365 posts
 

Not an expert but your headphones are probably enough load to keep your transformers from being damaged but I'm not sure.   The Senns are listed a 300 ohm which is kindo high.  The Hifiman are 50 ohm which should keep your amp happy.

I'd be trying to figure out why my system is so harsh.

What are you feeding it with?  Many DACs and preAmps are also a headphone amp which would make more sense.  Your amp is heating up the room with 300+ watts of power to drive a load that a preamp can drive.

Jerry

noromance's avatar
noromance
9,434 posts
 

How are you connecting the headphones to the Ref 75? 

mewsickbuff OP
233 posts
 

Here’s my system.

Computer with Signalyst HQ Player

Denafrips Terminator Plus DAC (No HP access) Got this a few months ago. Before this had T+A DAC8 DSD. (No harshness)

Audio Research SP 20 Preamp (has HP access sounds good but with a bit of sibilance)

Audio Research Ref 76 Power Amp

(Headphones run through speaker taps with a WyWires connector which sounds sublime). Can’t load a picture but the connector is basically a 4 prong XLR on one end with 4 female speaker tap inserts on the other end-2 left, 2 right).

The volume set for the Senn HP’s is around 3 and for the Hifiman HP’s is around 13.

The ARC power amp is newly acquired. I thought there would be better synergy after I started hearing the harshness with my solid state power amp (Primare A32). But the SS had been sounding very fine. The other new acquirements have been power cords (2 Silnote and 2 Wywires) which I got a few months ago. Before that I was using some 10 gauge generic power cords bought from Amazon without problem.

erik_squires
15,682 posts
 

I think it's odd the title is about frequencies that hurt your ears and then we are talking about Sennheisers.

Maybe we should talk about what causes your ears to hurt and how to correct that?

More to discover