@lowrider57 Thank you for the kind words. As best I can tell, the crossovers are, and always have been separate. From the response I’m getting on this thread they may well not be stock. In any case there are others for sale, so I’m not as worried about the ‘Bass Alignment’ option as I once was. The bass is powerful and clean without any additional equalization. Thank you for your concern.
Bi-Amping Options B&W 801 Series 2
New to me Bowers & Wilkins floor-standing full-range monitors with two sets of binding posts.
Currently have dual MC252 solid-state amps (with autoformers) connected as follows: (1) to both bass drivers and (1) to midrange and treble drivers.
Meanwhile, I have a Rogue Audio Stereo 100 sitting idle (although I could hook it up to my vintage Warfedales). I’m wondering if I would be better served by bridging both the MC252s and putting them both on bass duty (500 Watts to each driver), and put the Stereo 100 to use driving the midrange and tweeters. What do you think?
Especially interested to hear from someone with experience driving this particular speaker, which sounds wonderful, by the way. My system is fully described (but not well pictured) under my profile in Virtual Systems. And, if anyone has a lead on an original Bass Alignment filter, I’m all ears.
- ...
- 22 posts total
With identical amps you are better off splitting them horizontally. That is, one amp per side. This spreads out any current demands on the power supply more evenly. The alternative puts all the strain on the bass on one amplifier's power supply. Also, PS - Bass alignment filters can be fully compensated for in Roon using the DSP features. |
@erik_squires Hi Erik. Paul McGowan did a video on horizontal and vertical bi-amping. He said horizontal configuration is better for using different amps, one for the mids/tweeters and one for the woofers. He said vertical configuration is better for identical amps, one for the left channel and one for the right channel. |
@tomcarr I’ve never seen an impedance curve for the 801 S2, but I checked the user manual specs and found that while they are rated at ‘Nominal 8 Ohms’ in parantheses immediately following it reads “not falling below 4 Ohms.” I expect the drooping impedance would most likely occur in the lower frequencies. I think I’ll try the MC252 taps for the low frequencies over from 8 to 4 Ohms. @erik_squires Point taken on using identical amps as monoblocks. To be honest I was a bit intimidated at the prospect, I was afraid I might blow something up. But there is plenty of protection built into the McIntosh amps. I may try to source an MC2255 for the XRT20s and move the MC252 back downstairs for the B&Ws, or possibly bring the 65 lb. Rogue upstairs for the XRT20s, although the XRT20s could bring the Rogue 100 into clipping, and does NOT have the protection the McIntosh units provide. I think my current configuration makes the best use of the power I have available. |
- 22 posts total