Levinsos 585.5 No Power Out. - Assistance?

Also when i enter standby from on i hear two clicks back to back the first lower pitched and the second higher.     When turning back on from standby one limmediate ouder click with a softer click about half a second later.

Here is what I did

1.  Standby mode is green by default.  No power out.  Entered standby.  Power off from back switch.  Power back on hear two back to back clicks.  Select inputs.  No power out.    

2.  Select power save.standby mode.  enter standby.  No clicks.  Power off no clicks.

3.  Power on faint click. Select inputs from standby, no clicks, no power out. 

4.  Select nomal standby mode.  Enter standby mode, no clicks.   Power off at main switch.  Two clicks back to back one lower pitch next one higher.

4.  Power on.  One faint click.  Select inputs from standby, no clicks, still no power.

Those relays should only engage when entering standby mode. If you turn on the amp and the relays click without going into standby, there’s a problem.

You can also try disabling [Auto Off]. Then turn off the power and start it up again. If this fixes it then it’s the auto off circuitry that has the problem (most likely a capacitor in the timing circuit is shorted) and the amp goes into [Auto Off] immediately on startup.

Those are the only two things I can think of without a schematic.

Ok.  So what i mean in my post is:

"Power on" or "power off" means from the main switch on the back.

When i power on the amp always enters in standby after the " mark levinson plesae wait" boot process.

When i say "select input" I mean going from standby mode to on mode from the remote/front buttons.

I also had auto off disabled when i did it.

But, nothing worked.