Crossover Redo on my Amrita Audio Floorstanders

Yes, Amrita wasn't a very known brand and I find very little discussion about them. Especially my model. 

Clarity cap CMR’s and Mills resistors or Path can be a nice option maybe start off on tweeter section. There are a lot of nice caps out there. just need to know if you like the Juniper or Vcap sound or what’s in between.
 

Do the best you can with your budget. Sometimes you can find used caps with your values needed, no break in needed most of the time. Those CMR’s took a long time to settle down.  I tried Sonic caps there were okay but I would try others.

A good quality copper internal wire is always nice. On one set of speakers I ran external crossover. Not sure it made a difference because never heard upgraded crossover inside the speaker.

Can you still read the values printed on the crossover parts?  Unless you can find a schematic, that's likely your best option.  If they're not legible, my educated "guess" is that the measurable crossover values should still be pretty close to original since they're in a passive circuit.  If you measure the parts from both speakers you'll double your sampling number....if the parts are very close to each other, I'd think that'd be a pretty good starting point. 

I'd opt for non-inductive wire wound resistors vs typical sand cast.  Air core inductors are preferable to iron core IMO.  Try to get the DC resistance of the inductors as close as possible to the originals....a few tenths of an ohm change shouldn't make much difference, but close is good....obviously you want the inductive value to be as close as possible.  Good quality caps should help too.  Sonicap, Clarity Cap, Mundorf, Solen...there are dozens to choose from, and all have their fans.  Caps in particular can take a while to burn in, so be patient.

It'd be a good time to replace any ferro fluid if the Vifa tweeters originally had it.

Might as well upgrade the connectors to pure copper, and the wire if there's not something good in there already.

Dunno if this will help, but I found a discussion of the Amrita Audio speakers at DIYAudio.com https://www.diyaudio.com/community/threads/crossovers-for-amrita-towers.291004/

I was going to say that DIYaudio is THE place to go for advice on this kind of question. Lots of builders there.

I would NOT do a rebuild without understanding the original state of the speakers. I’m not sure about this brand, but for instance, Infinity had such wonky crossovers and impedance curves that attempting to replicate the original is a bad idea.  Some Focals are the same.

Assuming the original crossover design is worth keeping, you’ll need a DATS or similar to make sure you compensate for any changes in ESR or DCR of replaced caps and coils.

I just redid the crossovers in my speakers.  I used the exact same values but upgraded all the components and added bypass caps to the mids and highs.  I also verified the resistances on the inductors as this can change the performance of the system.

My new components were so large that I decided not to shoehorn them all inside and moved my crossovers outside the speakers.  

I spent over $3000.  You can see photos of the completed crossover in my virtual system.

The improvement was huge and at the same time subtle.   Very refined. 

Jerry