2. amps-preamps
  3. 187320-186532

Is my amp good enough?

Hello everyone. New here and looking for some opinions.

My system comprises of mostly NAD components. The pre amp is the C165BEE and the amp is the C275BEE. They are currently driving an older pair of Monitor Audio Silver 8's. I have always been rather happy with this set up.

I am now looking at upgrading the speakers to a brand new set of Monitor Audio Gold 300 5G speakers and I am wondering if my amp has what it takes to get the best out of the incoming speakers. I am not sure if I would get an honest answer from a salesperson as they might convince me I need a $6000 amp to drive the speakers.

I have included the specs on my amp and the speakers I am looking at. Thanks in advance for any advice.

Some details:

NAD C275BEE

OVERALL SPECIFICATIONS

FIXED IN, SPEAKER OUT

Continuous output power into 8 Ω and 4 Ω (both channels driven) >150 W (ref. rated THD, 20 Hz – 20 kHz)

Continuous output power into 8 Ω (Mono, Bridge mode) >330 W (ref. 20 Hz - 20 kHz, <0.02% THD)

Rated THD (250 mW to rated power, CCIF IMD, DIM 100) <0.008 % (ref. 20 Hz - 20 kHz)

Clipping power (4 Ω and 8 Ω) >170 W (ref. 1 kHz 1% THD)

IHF dynamic power - 8 Ω 250 W

4 Ω 410 W

2 Ω 600 W

IHF dynamic power (Bridge mode) - 8 Ω 800 W

4 Ω 1200 W

Peak output current >50 A (ref. 1 Ω, 1 ms)

Signal/Noise ratio >102 dB (A-weighted, ref. 1 W)

>123 dB (A-weighted, ref. 150 W)

Damping factor >180 (ref. 8 Ω, 50 Hz and 1 kHz)

Frequency response ± 0.1 dB (ref. 20 Hz - 20 kHz)

3 Hz - 100 kHz (ref. -3 dB)

Input impedance (Fixed IN) 10 kΩ + 200 pF

Input impedance (Variable IN) 100 kΩ + 100 pF

Input sensitivity 1.2 V (ref. rated power)

Voltage gain 29 dB

Minimum input level for AUTO TRIGGER 10 mV at 1 kHz

Time to power OFF at no signal in AUTO mode <10 minutes

POWER CONSUMPTION

Normal operation 312 W (ref. 230V AC 50 Hz; 120V AC 60 Hz)

Standby power <1 W

Idle power <100 W

 

Monitor Audio Gold 300 5G:

Specifications
System Format 3-way
Frequency Response (-6 dB) 30 Hz – 50 kHz
Sensitivity (1W@1M) 90 dB
Nominal Impedance 4 Ohms
Minimum Impedance 3.5 Ohms @ 1 kHz
Maximum SPL 117 dBA (Pair)
Power Handling (RMS) 250 W
Recommended Amplifier Requirements 100 – 250 W
neversatisfied
kennyc
1,655 posts
 

OP congrats on your decision. Frankly I’d expect a significant sonic uptick after 20yrs and moving up the product line and Monitor Audio’s innovation reputation with very positive reviews.

Now that your speakers are sorted out there’s more sonic upticks to be had, say in the electroniics like the amp…

neversatisfied OP
70 posts
 

Yes. Amp next. Actually the Arcam used for the audition was pretty nice. It was the integrated A25 I believe.

mesch
3,529 posts
 

 Congrats on a your purchase. I am happy for you. Sit back and enjoy the speakers. 

kennyc
1,655 posts
 

Ummm, not to spend additional so soon, but maybe demo some amps at the dealer with the same MA Gold speakers. You don’t have to buy “now” but can gather info of your next amp upgrade. If you find an amp you like maybe later buy used to save some $. 

neversatisfied OP
70 posts
 

I am no different than most of us here. It’s an addiction. No doubt further upgrades will happen. But I will spend some time with the new speakers first, letting them break in. Then we will see.

I may add a slightly higher grade of speaker wire to go with them even though something in my brain still wonders if that’s snake oil. I have a set of Audioquest Type 4 on my Silvers now. Maybe bump them up and move the old Type 4 down to my Focal towers in my home theatre setup.

More to discover