2. speakers
  3. 137841-98494

How do you move HEAVY speakers with sharp spikes without lifting?

I have large (175 pounds each) speakers with sharp spikes placed on carpet. I would like to be able to move them a few feet by myself to tweak their positions but lifting them is obviously not an option (I can't even lift half their weight).

I currently use a convoluted method involving tilting them over about 30 degrees, slide a board under spikes on one side, and then repeat on the other side. The speakers almost toppled over the other day which would damage them.

I'm aware there are non-spike alternatives but do not have the money to spend on these options. Any clever moving methods out there? 

Thanks!
wahoospiff
audiotroy's avatar
audiotroy
3,798 posts
 
Here is the real question is why you would want to?

Normal setup protocall is to move the speakers without spikes, you can use carpet sliders or felt pads to slide the speakers on carpet or hardwood.

Then once you have located the correct position, apply blue painters tape to outline the speakers flnal position, then carefully lower the speaker on its side and reinstall the spikes, level and done.

Dave and Troy
Audio Doctor NJ
cerrot's avatar
cerrot
1,700 posts
 
Invest in a motorcycle jack.
kennyc
1,506 posts
 

Engine crane. 

ozzy's avatar
ozzy
7,485 posts
 

I use an air bladder bought from Amazon that I pump up (squeeze bulb) to lift a corner, then either remove the spike and put furniture sliders underneath or install the Herbies gliders under the spike.

For heavier speakers and alot of moving I would remove the spikes and use the furniture gliders until you find the spot and reinstall the spikes again with lifting them up with the air bladder.

You will need to lift all for corners separately with the air bladder, but it works very well.

ozzy

More to discover