Vibration Question


Warning to the sensitive: involves tonearm pods.

I know this topic is beyond the pale to some, but my tables cannot take a second tonearm (once upon a time, though, they did), and I enjoy variety in cartridges. I have bought four pods so far from Lee Drage at Acoustand, two plain and two with built in micrometer VTA adjustment. But I discover the airspace around the tables is too congested with six arms, as well as introducing some grounding issues. So, as I told pindac the other day, I started to experiment with using two pods per tonearm. Not just a simple 'if one is good then two must be better' but for practical reasons. Firstly, a pod resting on three spikes weighs about 10lb, but it doesn't take much pressure on the distal end of the arm panel to cause it to tip. One can spoil a carefully set up alignment that way, and if it continues tipping a disaster could happen. So, I thought, why not place a pod under the distal end of the tonearm panel, and prevent that happening?

But then a second thought came along: if the second pod were firmly coupled to the panel, I would double mass and damp vibrations even more. That's a bit theoretical to me, as my oak chest weighs ~350lb and I can stamp on the floor next to it and not disturb a playing stylus. But rigidity is rigidity. So I asked Lee if he could make me a double ended panel with an SME mount centred in the middle. Roughly, like this:

He agreed, and pointed out I would have to forego the VTA adjustment, unless one were to place a screw at each end! I can use the SME mount itself to adjust VTA. though, so that's OK.

Here, finally is the question: he thinks I am simply introducing twice as many vibrations (external, I think he means) into the tonearm by having it rest in two sites on the oak chest, and that I would be better off having one end of the tonearm panel free-floating. My view is that rigidity is paramount, and if a built-in tonearm on a table is firmly coupled to the table then I am moving a bit closer to that ideal by having a firmly coupled chest-table-pod system. What say you?

dogberry

I guess you don't want to hear my real opinion, which is that outboard arm pods are a bad idea in the first place.  But if you must have one in this case, why not have your constructor build you ONE pod that works better for the SME mount than does his current version, with the cantilevered mount board. Because I agree that the unsupported cantilever is a really bad idea.  Two separate ones is better in some ways but worse in other ways.  I would go back to the drawing board.

I am in agreement with @lewm 

Just because you cabinet weights 350 lb this does not mean that it does not resonate in any way. Judging from the construction I can see, it does. Ideally you would rigidly mount the turntable and tonearm pod to an isolation platform.