@billstevenson I think the reason I wanted to try an MC is because all over the various forums there a "you are missing out on something" attitude by some by using a MM. I see there are a few using Denon 103's or the ZU modified versions on 1200gr's, however, there others that say 103's are a terrible match for the GR tonearm. For 78's I have a KAB concorde and a OM 78 stylus. I listen mostly to Jazz recordings and Classic Rock.
Lowest priced MC thats better than a Premium MM?
I’ve only used MM’s with my Technics 1200Gr with Luxman Phono Pre. I’ve used a couple AT "540ML" series, a Ortofon black, KAB Concord with 40 stylus (very close to Ortofon Black in sound) and my current Nagaoka JT80BK (which I love). I tend to change cartriges (and keep them with headshell intact) at a point to where the stylus still has around 40% -50% life. I sometimes I switch out and listen to my older ones for a change of flavor.
I’m now wanting to try a MC however, I want to keep it under $1200 or so. An Ortofon SPU would be fun to try, however, from what I've read, I do not think its a good match for my tonearm. For my 1200GR, can anyone recommend a good MC Cartridge. I’m tempted to try a ZU modified 103r. Thoughts?
- ...
- 41 posts total
Well, many very decent LOMC cartridges have already been named, many of them made by Hana. Why not pick one and see for yourself if it’s a revelation? I’d only stay away from Denon DL103 variants and all HOMCs, not because those cannot possibly be good choices but because those are a bit off the question. By the way, I can’t recall whether your phono stage has enough gain for a typical LOMC (0.2 to 0.6 mV output at 3.54 or 5 cm/sec stylus velocity). If not, there’s another can of worms. | ||
@lewm This is the phono section specs for my Luxman
| ||
I had the Grade 2 Prime+ (~$1100) Zu 103 cartridge and within weeks of receiving it, damaged the cantilever. Somehow, I also managed to damage the internal wiring and thus could not be fixed due to the epoxy potting of the cartridge (became landfill as Zu only gave me 20% store credit). There are many better choices out there for modded Denon 103's - Musikraft, Mighty Ana Sound, VAS to name a few. | ||
Aberyclark, sorry I did not see your phono specs until now. If the 100 ohm load resistance at your MC inputs is fixed, you ought not to try to drive it with a low output MI, because those have a high enough inductance regardless of the stated internal resistance which may be low, to require at least a 500 ohm input impedance. You’re fine to use a high output MI into your MM inputs.For that matter, some LOMCs (e.g., some Denon and Benz cartridges) are also not a good match to a 100 ohm input Z. |
- 41 posts total