@ghdprentice do you go off a price for a minimum run?
In example, minimum run is 1m and it’s $850. I need 2m and that’s $1100 which is 10% of the component price?
Personally I base the ratio on a cost of min length run.
Cable upgrades
Happy Holidays to all!
I’m reconfiguring my system and am interested in upgrading my interconnects and possibly my speaker cables, and I was wondering if you could make some recommendations.
I was running Audio Sensibility Impact SE XLR between my Benchmark DAC3 HGC (as a DAC/pre) and my Benchmark AHB2 power amp. The amp is running bi-wired Kimber Cable 8TC (I think that’s the model #) to a pair of ATC SCM40 tower speakers. In this setup the bass is tight and the mids are clean - overall I’m quite happy - but sometimes I feel, for my ears, I’d love a bit more openness / brightness in the higher end.
My questions are: would improved XLR interconnects help to open up the top end a bit, without being harsh, and perhaps increase the dimensionality of the soundstage? Or would I be better off starting with upgrading the speaker cables? I’ve been looking at the Cardas Parsec level of cable, and could perhaps stretch to the Clear line, pending your recommendations.
Also, one other question: pending the possible move to 2 AHB2s (in mono-block configuration), do both XLR interconnects have to be the same length? If not, would it cause any timing issues between, say, a 2' XLR and a 6'?
I’d appreciate any guidance. Many thanks in advance.
Best, JAMES
- ...
- 137 posts total
I don’t think the generality is intended to be anywhere that specific, it’s more a question of are you fishing in the right hole. That said, yes, that makes sense. Then there is the big question of do these have the right tonal balance / synergy with your system. The way I use it is a starting point for what I am going to plan on spending… so if my component is say $12K I’ll start looking in the $1.2K range… used. I will do everything I can to get the very best (I do lots of research on the qualities of the wires and hopefully try them). My most recent upgrades have been from a knowledge base of forty years.. so, I knew what different brands sounded like and also the improvement in my preferred brand (Transparent) and so I bought all new. The most recent series upgrade was very significant. |
@ghdprentice oh of course. Agreed. Trying out Nordost Heimdall 2 on my Aurender N200 now. Lower than the 10% point of reference. Not an endgame by any means as well but a very pleasant surprise and a sneak peak into what Nordost power cords can do on a streamer. |
@ghdprentice thanks for the rule of thumb info. A very helpful guideline. So, for example, looking for PC and USB for my Lumin U2 ($7,500 Cdn) I’d target cables in the $600-800 used range? And would that spend be for each cable, or both together? And would this apply for most components, given that they would need both AC and interconnects of some kind? @audphile1 What PC were you using before the Heimdall? I’m researching an upgrade from my AQ Coffee USB…and also considering upgrades from stock PCs… Thanks, JAMES |
- 137 posts total