Bananas rule, spades drool. End of discussion.

Amen to that.  I have been dealing with these while. My speaker terminals are up high.  I had bananas bend at the shrink wrap from the weight of the cables so sent them back and had spades put on them.  Wont stay tight.  I found some right angle banana plugs, fancy Rhodium coated ones.  Then the tighten and you can't pull them out and no weight hanging and bending of cable.  Worthy topic, thanks

Both bananas and spades are useful to me, depending on the given connection/reconnection need(s). One’s for eating, one’s for gardening, so to speak.

I think no need for absolutism in this area. 😉

I checked my spades (2 spades on the amp end in combination with 2 bananas and 4 spades on the speaker end) tonight, and they were tight.  It's been at least two or three years since I messed with them at either (amp or speaker) end.

Hmm….  Not if it’s the type of banana plug that spins.
Then one always has a loose compression connection. 
 

if you tighten your spades enough so they don’t loosen it is a much tighter connection then a banana plug. If the spades loosen this is a poor user issue.  

@horstmann I didn't mention low mass since most here don't consider that.  Since you do I'll share that I make my  own low mass binding posts by pressing an OFC copper tube through the center of a bored out 3/8" threaded nylon rod. Perfect match for the low mass BFAs.  PM if interested in the details.

I also agree the simple BFAs seem indestructable.

Jerry