SVS Subwoofer Connection

What about the SVS SoundPath wireless adapter?

Hello, 

Just run it via the directions but use very inexpensive speaker cables to the subs. It is a signal the subs are grabbing. You lose about 1/4 ohm of resistance from the amp but you won’t notice it in the sound. If you do it your way you will really degrade the sound from those amps. 

The wireless adapters are good for home theater but bad for two channel due to the time delay. KEF and JL Audio even say there is a time delay with their wireless connections. Bass is already slower than the highs. You will just delay it to much and might be running out of phase. 

You have to check to see if there isn't a high-pass filter on the speaker outputs of the subwoofer.  Sometimes they put a capacitor in series with the output to the speakers to limit bass to them.  This may be detrimental to sound quality if they didn't use the best quality capacitors.

I had the exact same question- I had been running separate speaker wires to my subs from my amp.

Audiogon Discussion Forum

The short answer is you can just jump from the speaker post to the sub. I know your specific query was sub to speaker, but pretty similar. I'd go from speaker to sub, as the only difference in your post.

I wanted to remove  24 foot runs of  wire and their susceptibility to RF, and and a general tidying up. It all worked out just fine...