Mint Protractor. A Pretty Nice Alignment Tool


So when I bought my Triplanar the seller had a Mint protractor for it. It was cut to be used on a Garrard 401. As luck would have it, the spindle size is the same as the one on my Scheu Analog table. So I put it on the table this morning, and fine tuned the cartridge alignment. My overhang was off just the smidgiest of a smidge, and I made the slightest of corrections to the cantilever alignment. Using an overhead light it was very easy to see the alignment lines. Playback showed the efforts yielded positive results. I have to say this is a good product. Nothing magical about it, just a clean execution of an arc protractor.

neonknight

Dear @neonknight  : The MINT LP protractor is a dedicated one made it for an specific P2S distance and does not works for a different P2S distance.

Normally those protractors were made for Stevenson Alignment and under ask by customer for Löfgren A or B.

 

Regards and enjoy the MUSIC NOT DISTORTIONS,

R.

 

@rauliruegas Spindle to pivot is the same regardless of the table. I am at correct spindle to pivot so the protractor arc will be accurate. 

No, it's not.

Please make a revise to the alignment Löfgreen equations where the only input parameters are: tonearm EL and most inner/outside distances. Those equations gives to you the overhang and offset angle but it does not calculates the P2S distance that's the EL minus overhang. Maybe I'm wrong and you are rigth.

 

R.

@rauliruegas Well spindle to pivot is correct as the spindle is always at the same regardless of the table because the spindle is always at the center of the platter. So the size of the matter does not matter, whether it’s 10 inches, 12 inches, or something in between. Nor does it matter if it’s a Garrard 301 like the previous owner used or my Scheu or a Denon. Spindle to pivot is not going to change due to turntable manufacturer. A mm is a mm no matter what table it’s measured on. 

The cartridge traces the arc spot on from outer to inside position. The cartridge offset aligns the cantilever at both grids. What more do you want?

The null points are marked and I would have to reference them against the alignment types to see which it is. Or email Mint. I am not in a hurry to know since the cartridge tracks extremely well. Have an Audio Tekne MC-6310 set up at this time. Eventually I am going to move my Proteus to this arm when it’s time to send the Audio Tekne off for a new diamond. It has a bit over 500 hours as I recall.

@neonknight  : Please do it a favor and don't insist in something where you have a clear misunderstood.

The designer protractor you own was in specific for a P2S distance to achieve minimum tracking distortions in the designer alignment choosed and that's why you:

 

" My overhang was off just the smidgiest of a smidge, and I made the slightest of corrections to the cantilever alignment. "

So, you have higher distortions down there in your cartridge/Sheu tonearm.

 

Löfgren equations inputs are the ones I pointed out and the output from those equations gives us: both null points, overhang, offset angle, linear offset and trackind distortion.

 

Where do you see P2S distance : nowhere.

You have to understand the Löfgreen equations. You are not the only audiophile with that similar kind of misuderstood, even M.fremer less than 8 years ago had that same misunderstood till he learned.

 

Sorry.

 

R.