Turntable Isolation

My gear sits out in the middle of my room, no walls around it. 

Travisg,

You will enjoy the Townsend.  I have a bunch of those cork/rubber blocks.  They are OK...but in a different league.  And I also have the maglev platter on my table and it's all on a Salamander rack.  A bit of overkill.

Happy Listening

@elevick have you tried Mapleshade’s complete vibration control system with the wooden platform and the brass footers along with the cork/rubber blocks?  I am not suggesting that the blocks alone are adequate.  Not that a VPI table really needs more mass, but the wood platform adds significant mass in between the blocks and turntable feet/brass footers that helps reduce vibration coming from both the table and from the floor/room.  It is also both less expensive and less elegant than the Townshend platform, which is within the OP’s budget.  But some folks may like the quaint funkiness of the Mapleshade design.

kn

So the Townshend platform did not solve the footfall issue. Back to square one  

I hate to say I told you so. Sorry about that. I guess I did not comment until after you had ordered the Townsend. All those feet thingies are also garbage. To properly isolate a turntable the suspension needs to be tuned below 3 hz, three bounces every second. That is so slow you can count it. 

Try this experiment. Put the turntable on the floor. If the footfall problem improves at all a shorter more stable rack will also improve the problem. Then down the line you can either replace the floor or get a Sota Sapphire, Nova or Cosmos. Easy choice I think. Hanging the turntable is another viable solution. People laugh at it, but it will reliable vanquish the footfall problem. All you need is a drill and a ladder. Get a big butcher block carving board, 8 hooks, chains and turnbuckles.