Transfiguration Phoenix S cartridge - impedance loading recommendation?

Many thanks @rauliruegas

I own a Transfiguration Orpheus L, which is also a low impedance cartridge.  It is not sensitive to loading and I run it with 360 ohm loading.

If the internal resistance of the Transfig is 2 ohms, not 1 ohm, you might be slightly better off setting the input impedance of the Accuphase to any number above 10 ohms. This is only because you want ideally the input Z to be at least 10X higher than the output Z, for any two components where one drives the other. It primarily affects the efficiency of energy transfer, in this case signal voltage. The rule is rather plastic when it comes to phono cartridges driving phono stages, so I would not worry about it much, but maybe try 30 ohms or higher and see whether the system becomes a bit more dynamic or produces higher SPLs at lower settings of the attenuator. In some cases, where the inputs have some capacitance, the ratio also affects transfer of high frequencies. In the case of a bad mismatch, you’d expect some audible roll-off in the treble region. I doubt that would be a noticeable problem with your current choice of input impedance.

I had discussed this with Bob Clarke, the distributor for Transfiguration before they stopped production and he felt that the Transfiguration carts were smooth enough on top that the loading became more of a tone control. The preamp we were discussing had loading from 100 to 470 and he said he even ran his at 47k. He initially suggested the 470 setting, but said it would work fine at 100. Just go with your sonic preference. We didn’t discuss any values below 100. Disclaimer- we were specifically discussing the Orpheus, which is low impedance, although not as low as yours. 

Many thanks to everyone for your feedback and expert advice - much appreciated!

I will try 30 and 100 Ohms and not 10 ohms as the internal impedance of the cartridge is 2 ohms.