Run at least four dedicated circuits; minimum 20 amp service
Help me build out my first system
Hi All,
New Audiogon member here, been a lurker for some time; thanks for all the tremendous info! I’m in the process of building out my first system and am hoping for some recommendations on streamer/dac and preamp. A friend has been kind enough to set me up with a McCormack DNA-1 (not yet in my possession) and a pair of Focal/JM Labs Electra 926s from a client who wanted to upgrade.
At this point I’m trying to put together two sets of options: First, which components might really make the setup sing, not worrying much about budget (without going too nuts). And second, assuming a budget around $3000-$4000, what’s the best I can do?
The setup will live in a 14’x24’ room, and I’m in the process of building some panels for appropriate room treatment. Tidal is currently my preferred source, but am open to change based on compatibility req’s or being convinced of a better alternative for this application. I’d also like to allow for incorporation of a new turntable down the road.
Am I thinking about this the right way? Thanks for your thoughts
- ...
- 38 posts total
Oh no, that's bad advice. I'm all for multiple dedicated lines - although many believe one should suffice - but a 20A line is the maximum you want to install. Here's a 120VAC 20A receptacle, which will accommodate almost any audio component:
Here's a 30A receptacle. Your gear isn't likely configured for this:
What I do like is derating the line, such as using 8AWG wire for a 20A circuit with a 20A breaker. But using a 20A receptacle with a 30A breaker wouldn't meet code in my state.
|
I use a single run of 8AWG on a 20amp breaker to a L15-30R. A L15-30P with 8 gauge feeds a 4 gang box of 20 amp receptacles.
|
The plan is to run two dedicated 20A circuits. @janewyman can you explain the added benefit of having four (presumably one for each component)? I can’t imagine it’s an issue of power draw, is it for isolation purposes? I’d like to wire in a snap switch or other contact switch to physically break the connection to the breaker/panel when not in use. Anybody familiar with something like this? |
- 38 posts total