Spatial Audio Raven Preamp

Wash your hands often! Seriously, it's the single most effective way to ward off bugs from the mass transit petri dishes. Wish I still lived in Portland, I would have loved to meet you guys.

Imagine high speed levitating electric trains down the insterstate medians..... They would be far more efficient than planes for the 500 mile or less journey.  They have trains that go 199 mph in Japan.  Imagine just 120 mph.....  a few hours and you are across a couple of states and you can walk around, go down to the club car for a beer, etc...   Contrasted with spending 2 hours in airports on either side of a 90 minute flight in a tuna can.  Sure, for cross country flights the plane is better, but for the 300 - 500 mile journey... I would love a train.

UK is now linked to Mainland Europe with a Trainline one service for high speed Pedestrian Transportation and another to replace the use of a Ferry Crossing for Vehicles.

The idea of Plane to Paris is not the commonly used idea anymore, the Train is very popular.

The Ferry suits those with additional time and on a tighter budget to transport a Vehicle.

I was listening to a Tim de Paravicini designed 300b Power Amp' yesterday, was using E88CC Input Tubes and had undergone modifications to utilise Interstage Tranx's in the circuit.

Very enjoyable it was too as an experience.

The Pre Amp' was a DIY Built Pass design using a Khozmo VC.

I made all who were at the audition aware of this Thread and the other, the Raven is further spoken off within the UK.  

Interesting thread. I recently demoed a budget preamp in my system and was surprised by how much more dynamic and alive it sounded compared to using the volume control from my dac. If there was any loss in resolution, I couldn’t hear it, and the improvements were dramatic, so I am now in the market.  A couple of questions:

1) how much gain does the raven have, and is it the same balanced and single-minded? I don’t want to have so much gain that the volume control is touchy.

2) I’m currently using single engine connections from my dac to my amp. I’m going to need to buy a new set of interconnects.  Any recommendations regarding whether I should stay single ended, run balance connections into the raven and single ended out, or sell my single interconnects and buy two balanced ones. I really like the iconoclast cables I have and they will add to the cost.

Thanks. 

Hi

The Raven gain is about 13.9 dB (5X voltage gain).  The RCA and XLR inputs have the same gain.  The Khozmo volume control has a very nice log taper and you should have good adjustability in most systems.  Not touchy.   

I would run XLR from DAC to Raven if you can, but it is not required.   It will generally sound better with most DACs.  Also, if you ever change amplifiers you can run XLR out to an amp with balanced connections.   The RCA output of the Raven will by definition have less gain.  That said, there is plenty of gain to drive almost any amplifier.  I believe Spatial has a return policy if it doesn't work in your system, but honestly, it will work well with most anything, single ended or balanced.