New Fozgometer V2 Can't Zero Meter

@stringreen  and others-

I still haven't heard back from Hi-Fi Heaven, where I bought it for the best price by far. But I did drop a text to Musical Surroundings. I'd say within 5 minuets of sending the text Ken Bowers called me. We chatted about all things related, I mentioned that I was about to do a re-calibration.

Ken says no to re calibrating the new V2's, stating that more people screw it up by doing so and they are calibrated from factory and would rarely need it. He says so much of online, as well as the manuals are misinformation.

Bottom line for me. So I can't adjust mechanically to zero the meter with ON/OFF zeroed meters showing (switching between ON & OFF and seeing a zero meter). I can zero the meter when ON, just leave it on while using it. If I shut it OFF it would show -1.5 (who cares, doesn't matter), I turn it back on and it is zero, so let it be. That is fine with me and doesn't matter. I got my readings and described my procedure to Ken with his agreement. He also says, although my arm looks a hair tilted high, it is that side I need to bring down thus trying to match the channel values from the high side to the lower values side. He says not to expect to match values but a couple divisions off each other is close enough, go with it. Of course, if you can match values that's good for you. Also, (as it applies to me) don't expect your tonearm to look like it changed position much. I tried all the simpler methods to set azimuth and keeping about 55% of my total tracking force distributed to my dual pivot point, I believe I was in the ball park.

Obviously, Ken is saying get it as close as possible and be happy with it. That works for me, The values I got agreed with what I thought I did but as I hoped, it told me I can do better giving me a base and destination to tweak towards.

I will patiently chip away at this now and also have to keep mindful of my total tracking force and weight distribution between the two pivots-

Thanks everyone!

Robes

You say you have a dual pivot point arm.....If it is a VPI, just screw in or out that pivot to exactly straighten the arm.

@stringreen Yes, I have a Prime. If I'm not mistaken I remember you from the old days on the VPI Forum, how I miss that, a treasure trove of info. Shortly after I bought the Prime they shut it down, really hurt, if I would have known I would have copied so much of it. Have crossed paths (actually always looked for Brf) with Brf on another forum but never figured where he hangs his hat these days.

But, he contributed on a forum where I learned all about the ruby tip/skate plate and all, so I did that upgrade. He also posted on the % tracking force to apply (and how) to the additional pivot as well as using the pivot to adjust Azimuth. I did the whole Sota motor,Condor & RoadRunner upgrade (this was from readings on VPI Forum at the time), and many other upgrades to now. After this final tweaking to the setup I will finally use the Prime table (original motor never turned on). On & On I could go-

Anyhow, I've read many of your posts, mostly here and there and have to say were a big influence in my decision to enter the land of Foz-

Take care everyone-

Robes