Subwoofer Advice


I am running a pair of Martin Logan ESL 13A speakers (24-23,000 Hz). I would have thought with two 10" woofers there would be more bas (the base level dial on the rear of the speakers doesn’t seem to cut it either).

In the past I had a pair of ML Spires (29-23,000 Hz) with only one 10" woofer that had so much base, I sold my pair of ForceField 30s. Not the case with the 13A’s.

I don’t have a lot of room, maybe 16" or so square and I was wondering about a pair of SVS Micros. Do you think they would complement the 13As or do I need something bigger?

Martin Logan has come out with a few new subs lately; do you think I should keep in the ML family?

Hoping to come in under $2K, so used is fine. Thanks all!

I should also mention I’m limited on space so placement would likely have to be on the inside or the outside of the main speakers (same back wall).

 

128x128navyachts

Not at all, you are going to use them. The M1 will drive your Coda Amp and the Benchmark will drive the KEF amplifiers. The SHD Studio will provide the crossovers, room control and bass management as well as streaming and source selection like any other preamp. 

I would use the Rhythmik F12 or F12SE which are servo-controlled to match the speed of the ML ESL's.

@mijostyn couple of quick question, how would I wire up the KEF subs?

1. With the way my system is now - no miniDSP? My amp doesn’t have SUBs out.

2. With miniDSP and the Benchark DAC?

Would the miniDSP work magic maybe with just my Martin Logans, without purchasing the subs? It seems with the ARC Genisis program, the bass can be found with the two 10" woofer already onboard the MLs? I'd just like to integrate the bass better to the room.

 

 

Thx.