2. vintage
  3. 191421-195999

Using a power strip in an old home that was build back in 1955

I'm not sure if this post is in the correct topic, but the title says it all. I live in a house that was built back in 1955 and this house has very few grounded outlets. I use power strips throughout the home and have never had a problem occur.

I plan to upgrade one power strip and my question is if I use a power strip like this one

https://www.amazon.com/SUPERDANNY-Protector-Outlets-Charging-Extension/dp/B08Z2ZKVXX/ref=sr_1_2_sspa?crid=3SBFJHLALO6QN&dib=eyJ2IjoiMSJ9.s0_HlP9WURLAXog0sGN2IYFWFyxz8mv_FlE-jBVldyFzMbcrgFRL4s7omCYnD5Tme9-N7eaM7TU6cSHLYvmCSKosQF2WDkWUCk3wcKYlkNkyj3aruYly_umT5WfWzdUCwVRgX2JMPDUc9Rs8xRlBnwjEybJuQfD7TVsKwe6XF_2GNQMXRQH35YxULNEytSE00WYIjIs23hTulfn45F3-aaYw2nOkns730GHg4Pb2vHw.1VcY2JcKKBP7V9hL1YgK-OAGfbzc_GHUvAOvOyqbJbE&dib_tag=se&keywords=power+strip+24+outlets%5C&qid=1726891536&sprefix=power+strip+24+outlets+%2Caps%2C293&sr=8-2-spons&sp_csd=d2lkZ2V0TmFtZT1zcF9hdGY&psc=1

Would I have a wiring fault as the outlet is not grounded?

This power strip doesn't have a yellow light built in.

https://www.amazon.com/TROND-Protector-Rotating-Extension-Essentials/dp/B0D1K55GPC/ref=sr_1_9?crid=3SBFJHLALO6QN&dib=eyJ2IjoiMSJ9.s0_HlP9WURLAXog0sGN2IYFWFyxz8mv_FlE-jBVldyFzMbcrgFRL4s7omCYnD5Tme9-N7eaM7TU6cSHLYvmCSKosQF2WDkWUCk3wcKYlkNkyj3aruYly_umT5WfWzdUCwVRgX2JMPDUc9Rs8xRlBnwjEybJuQfD7TVsKwe6XF_2GNQMXRQH35YxULNEytSE00WYIjIs23hTulfn45F3-aaYw2nOkns730GHg4Pb2vHw.1VcY2JcKKBP7V9hL1YgK-OAGfbzc_GHUvAOvOyqbJbE&dib_tag=se&keywords=power+strip+24+outlets%5C&qid=1726891536&sprefix=power+strip+24+outlets+%2Caps%2C293&sr=8-9

I'm not an expert in the field so that is why I'm asking.

gamekid
Post removed 
ecat026
13 posts
 

From my research with a similar issue, code allows you to install ungrounded 3 prong receptacles IF a GFCI is installed upstream and the downstream receptacles are wired to that GFCI's Load. The newly installed three prong receptacles must then be labeled "protected by GFCI" or something similar, I don't remember. Something to look into for safety. 

whart's avatar
whart
3,021 posts
 

Upgrade your electrical system. The house I live in now was built in 1880. It probably had no electricity when built and over the years, probably went from 60 amps to 200. The previous house I owned in NY was originally built in 1780. I had the electrician pull out as much unused wire as possible and rewired the panels-- it was over 6,000 sq ft, not including outbuildings, pool, etc.

Worth doing right. It's not just safety, however important; it is also quality of power. 

This is not an area where you look to save a few bucks. Get it done properly by a competent electrician. Far less costly than black boxes and mystery tweaks. 

bigtwin's avatar
bigtwin
1,178 posts
 

Where's the stereo equipment?   😆

motown-l
181 posts
 

I also live in a 1955 era house. Same lack of grounding. My grounding issue was so bad, you could feel low current levels on the metal faceplates of components. 

My attempt at a solution was successful. I bought a $200 or so Panamax surge protector/line conditioner. No more "hot" faceplates. Couldn't say if anything sounds better due to the line conditioning, but I don't feel like I'll get zapped by my ungrounded audio equipment.

More to discover