Using biwired cables on speakers with only 2 connections

If it made an audible difference and probably doesn't, it would still drive me nuts having the 2 ends flopping in the breeze. I would do what do what @audphile1 suggested and get the banana to spade adaptors. Also you won't need to cut up your good cables to get bare ends. 

On the bi wiring subject I normally agree the differences are small except for some Usher BE 718s I had. There was a definite improvement bi-wiring. No I didn't measure anything. Could be that the combined gauge of the bi wire cables were better suited to the speakers and a single strand of that gauge would have done the same thing. no idea. 

@califortini 

I cut out the edge of a box and slid the end of the cable inside the corrugated piece and then just put some electrical tape over it to protect the connection.

So basically one side is connected and one side isn't and according to the cable manufacturer, transparent, it shouldnt matter.  But I tend to think cutting the gauge effectively in half is not a good thing.  

when You have really expensive cables it's kind of hard to sacrifice the biwire end. And also when you biamp, it's twice as many cables.  It's not a perfect world.

Don't really hear any difference it would be nice if I had the full gauge of the cable available.

 But I tend to think cutting the gauge effectively in half is not a good

I tend to think that you are correct.

Thanks all. I'll also drop a note here once I get the speakers hooked up in a week if I can wire them together on the post or if I need to cap the binders. 

Send them to the manufacturer and have them reterminated