Magnepan LRS+ resistors on the tweeters… which?

Putting a resistor on Maggies to solve a HF problem would be a last resort for me. Placement, toe in or toe out, different amp, tone controls, PEQ, etc., would all be tried first.

Why is it a last resort? If a manufacturer put it on the crossover instead or a guy like me sold you a modded (’non bright’) magnepan and you just didn’t know about it, everything’s ok then?

Wondering what the logic is around here.....Is the key here that you didn't know about it (so some belief system didn't intervene)?

From what I gather from the manual LRS+ are optimized to sound excellent in a good room (treated/ not too lively) and that they do, very much so. They included resistors to help correct a less than optimal room.

When I first got my pair, I found the treble had a bit too much sizzle when put on the more vertical aftermarket stands. I tried the resistors and it tamed the high end but they sound worse overall. After a little time that sizzle went away without using the resistors. My room is modestly treated and well damped and the LRS+ sound amazing in there especially with my two Rel subs helping out.

Here’s the blurb from the manual...

1. OPTIONAL TWEETER ATTENUATION: There are several reasons for possibly needing to attenuate the tweeters in the LRS+:
   1. 1. Recordings typically in the “pop” or “rock” vein often exhibit a pronounced rise in the treble region.
      2. The Magneplanar Quasi ribbon tweeter is very efficient in it’s total energy dispersion. If the surrounding walls are exceptionally reflective, the overall perceived acoustical balance can be tipped toward a “hot” high end.
      3. Put A and B together and it can be unbearable.
2. Attenuation is accomplished by placing a resistor in the attenuation position on the connection plate (see Figure 1and 2 below). Provided with your speakers are 1 and 2 ohm resistors for this purpose. These resistors will provide 1 to 4 dB of attenuation. If you continue to have a brightness problem you might consider room treatment.

More than the treble issues of before, now completely fixed, to my absolute surprise it is the bass that is puzzling me, in a positive way.
With the Copland CSA70 the LRS+ is beautifully balanced with a total engaging and satisfying bass output: there is meat on the bones for sure, and no subwoofer is needed.