technics 1200 cartridge and preamp choices

for the technics (which i've had) i think the grado phono stage would be a very good choice. its a bit rounder and smoother than something like a dynavector p75 (which i have)... and will balance out the slight glare in the lower treble of the 1200 (not bright as in tizzy, but as in a hardness). also, for your setup (if you go with a 103), the ear phono would prob work very well if you want to spend a bit more. i thought 103 worked well on technics arem... (i am sure people will start to post that the denon is ultra low compliance (5cu)... it is still low compliance, but it is actually 9 or so cu when measured on the calibration that most of us are used to. denon uses some weird unit on there specs)

If you are set on using moving coil catridges, you don't want the Grado PH-1, it's only for moving magnet carttridges. You're going to need more gain for a Denon catridge, which has rather low output. To really give you better advice, it helps to know what kind of sound you are after. Do you prefer analytical or a lusher kind of sound? Does your system have certain sonic characteristics you want to enhance or counteract? My own prejudices and budget have led me to go down the path of moving magnet designs as opposed to the moving coils. If one is doing vinyl with budgetary constraints, there are some very real advantages to sticking with moving magnet or high output moving coil designs.

You could pick up a used Bellari for $150 and a new KAB Groovemaster for $200. I'm currently using this combination on my KAB modded technics 1200, and would highly recommend it. For what its worth, I've owned Creek, Dynavector, Monolithic, and Plinius phono stages. With high output cartridges, the Bellari is competitive with these much more expensive stages. Have'nt compared too many cartridges on the Technics, but the Groovemaster is an excellent cartridge (tracks well,low surface noise, easy to set up, no inner groove distortion, not too analytical etc).

Howdy. I also have a 1200 & went through a couple different setups before settling on the Shelter 501 & Krell KPE reference pre. I had tried a Grado Reference & their PH1 but felt the sound was a bit constrained. I had also tried a Black Cube & replaced it also. I find the Shelter along with the Krell pre gave me the widest sound spectrum and best bass response. Yes is was spendy, but worked out well for me.
-John

The Grado is designed for .4-4.5mv outputs, but the Denon is only .25. A higher output moving coil will work it would appear.