A little math is in order. Now, my tonearm wireing is too short to connect to my Preamp from its new location. RATS ! Twice over. I just luged out 31 ga. 9x9 copper via Nisson Japan, I scored 20 years ago. Back to work...
New Maplenoll Ariadne owner needing advice
I have recently purchased a maplenoll ariadne. I have tried to learn a little about the table but find very little information. I know the table was discontinued in the 90's but the little i have found indicated it is a very good table. I am interested to learn if there are any tricks or problems to optimizing this table. As most of you probably know, it is an air bearing platter and tonearm. I plan on putting my zxy airy 3 on the arm once I get it set up.
- ...
- 327 posts total
- 327 posts total