2. analog
  3. 1187909944

the dreaded breaking of tonearm wire...now what?

I just got a new (used) benz micro h2 in the mail and began my first install. Needless to say, didn't go very well. Actually, except for one tonearm wire breaking, it wasn't as bad as I thought.

So, is there anything I can do to salvage it? Or, should I just send it somewhere, or just a new tonearm cable? It's just the stock in the MMF-5, but don't have a budget right now for anything much better.

What would you do?

Good news: even though I only have sound through one channel, it already is an incredible difference. I think I need some extra counterbalance weight, as the force is tough to adjust. But already much better, except for the fact there is no soundstage with one speaker..

Thanks
pablo16
pablo16 OP
45 posts
 
Dan_ed: Where did you get the wire and clips...I'm thinking this might be a good time for me to do the same...

Also, I think i'll be able to use the same heat shrink, that is if I can get it back on the wire...
tpsonic
1,092 posts
 
Sorry to get back to you after the fact.Dan_ed has given you sound advice,
stringreen's avatar
stringreen
6,440 posts
 
Don't use a lot of heat..it will burn the wire - even slightly will change the sound. I'd send it out for Incognito. I did that to my Rega arm when I had it and the difference to stock was very much better.
dan_ed
2,451 posts
 
Michael Percy Audio. They have the clips, heat shrink and lots of wire to choose from. The Litz wire is a bit of a pain to work with and it may not necessarily sound better. But they have a good selection to choose from.
audphile1's avatar
audphile1
4,786 posts
 
Pablo, what did you do to damage the cable?
I will be installing a new cart pretty soon for first time.
Kind of wanted to know what are the DOs and DON'Ts when installing. Cartridge is Benz Ace. I feel pretty confident I can do it, just wanted to know what I should avoid.
Thanks!
More to discover