2. analog
  3. 1198340159

Problem - HF "Chirping" Using Turntable

To make a long story short, my PS Audio 5.5 preamp, Hafler DH-500 power amp and Acoustat 1+1 speakers have been thoroughly checked out, and they appear to not be the source of the problem below.

I installed a new Audio-Technica MM cartridge and since then (but the above components are "new" too) when my phono section is engaged, at high volumes there is breakthrough of a very disconcerting high frequency chirping or oscillation. When I move my TT to my (lower quality) home theater setup, there is no such noise.

So, I figure either my Tt (a KAB Acoustics-modified to play 78 rpm - Technics SLBD-era belt-drive TT) or the AT cartidge is the source of this noise or it happens to exist at the location of my system and the cartidge is amplfying it.

Any thoughts? My line-level channels are fine - silent.
toxrtp
dweller's avatar
dweller
3,786 posts
 
Make sure the belt on your TT wasn't twisted when installed. I twisted mine and it was making scraping noises.
crem1
672 posts
 
Re-install your old cartridge. Should the noise go away, you have learned its source. Should you install the old cartridge that now makes the same noise(es), the issue is in the P/A .

Before reinstalling the cartridge re-check the grounding wires from the TT and T/Arm. Make certian you installed the new cartridge's wires to the TT specs.

HF Chirping appears to me to be a compatability problem with the P/A. The only way to know is to reinstall the old cart.
honest1
586 posts
 
Does it do it only when the tuntable is turning? Will it do it when the pre-amp is set to phono, but the turntable is not turning?
toxrtp OP
6 posts
 
Problem solved. I "borrowed" a Grado Green P-mount cartridge from my local audio salon and it does not make the noise. I will contact the vendor of the Audio-Technica cartridge but, as it's months old (my system was down being repaired and upgraded for the past 8 months) I don't expect to receive much consideration From "the Needle Doctor", even though both the cartridge and extra 78 RPM stylus are essentially unused. It would be really above and beyond in terms of customer service.

Follow-up question: Given that I have a Technics SLBD-5 TT and only use it to play records that will probably never be available on CD, which means a few hours of play per year, is there any reason for me to upgrade my Grado Green P-mount to a Grado Red P-Mount?
More to discover