Denon 103r ????

Hdm Pauly(from earlier post as well) Gadfly thanks for the suggestions. I plan on getting the wood body, and will try to change the resistance in the phono. Reason for posting, was in hope of finding an immediate solution.

Come on Raul. All you have to do with a 103R is put it in a metal body and pot it and it'll be worth $5K and right up there with an Allaerts!

The Shure M97XE is better than the Denon?

I've also struggled with the edginess of the 103R. I realigned it several times thinking it wasn't set up properly. I added mass to the tonearm to accommodate its compliance. I damped the plinth to death. I tried several phono stages (Phonomena, Wright WPP100c, WPP200c, EAR 834P). I tried different SUTs (Lundahl and Cinemag). I tried loading at 40 ohms, 100 ohms and 500 ohms. But after all this messing around, I still hear some edginess. What's a fellow to do? yes, yes, take the plastic body off and try an Uwe ebony body. That's not out of the question, but why not try something different altogether?

And that's what I did... I picked up a Grado Reference Sonata. It may not be the last word in high end carts, but you know what? It's so much smoother than the 103R. And there's no fussing with tonearm mass, loading, SUTs, extra ICs. Just get it aligned, sit down and relax. There's something about the Sonata that sounds very nice. The timbre is realistic. The bass is deep. The top end is smooth and free of glare.

I haven't lost hope for the 103, but I'm frustrated. It requires so much tweaking. FWIW, I strongly recommend reading Romy's rant: Denon 103: myths and the reality

How does the 103R compare to an aftermarket mod like the Zu DL-103 (or any of the wood body versions available)? It was rather annoying to read the Stereophile review of the Zu DL-103 and not see it compared to the 103R.

First, I disagree with some of the people here. The Denon has a well deserved reputation; sorry you can't get it to sing.

Second, reverse the phase on the cartridge pins and verify proper phase on your system. I have found the 'R' to reverse phase.

Third, do not tighten the headshell screws very much - just tight enough to hold and that's all.

Fourth, check and verify that the stylus does not have a problem with azimuth. Use a 10-20 magnifier and make sure it's 90 degrees IN THE GROOVE - use a mirror or cd to help show it.

As Edle suggested, the Graham is not a good combo with this cart. Email Graham for additional advice.