seek advice on hum problem from phono preamp


My EAR 834P phono pre produces quite audible hum at the speakers. It is plugged into a Noisetrapper isolation transformer, which is plugged into another big NT isolation transformer. Probably not a ground loop: cheater plug on the EAR, or anywhere else, doesn't help. Using a Grado Statement Ref cartridge, which is unsheilded and was prone to hum pickup from the motor on a Rega TT, but isn't close to the motor on Thorens TD850; TT is far from the EAR. So the hum comes from the cartridge or the phono pre. Is this just typical of tube phono pre's (meaning, a SS unit is the only real solution), the EAR834P in particular or a defect in same? can the type of tube be a factor, do I need a different cartridge, or what? would greatly appreciate suggestions.
128x128lloydc
Post removed 
The powersupply transformer generates alot of hum. I rehoused mine in a separate remote box & solved the problem.....wonderfully quiet now!
Is this just typical of tube phono pre's (meaning, a SS unit is the only real solution), the EAR834P in particular or a defect in same? can the type of tube be a factor

This isn't normal behavior and you should be able to get rid of it. My 834P doesn't hum. I've never heard a tube hum so I doubt that's the problem. Try these things:

- Make sure the Grado is wired correctly. Check the connections.
- Move the TT away from any transformers or motors.
- What else is plugged into the Noisetrapper? Unplug it.
- Remove the Noisetrapper transformers from the picture and see if it makes any change.
- Ground the TT to the phono stage. Then remove the ground to see if it makes any change.
- Plug the 834P into a different preamp input.
You haven't mentioned if this is a recent problem or one that's existed since you installed your phono pre. I was recently befuddled by a phono hum problem, couldn't figure out why it was happening. Then in a moment of Homer Simpson "Duuuhh" clarity, I remembered I'd changed interconnects and that's when the problem started. The unshielded interconnnects were the problem, replaced them with shielded cables and the problem vanished.