Cartridge alignment channel balance measurements?

Check the posts regarding Azimuth adjustment. Use DVOM

No one I know uses channel balance to adjust cartridge alignment.

"Channel balance" means the relative strength of one channel vs. the other. If that's what you meant, it's unclear to me that measuring channel balance would be useful for adjusting any cartridge setup parameter.

"Cartridge alignment" usually means the combination of a cartridge's position along the headshell slots ("Overhang") and its angle in the headshell slots when viewed from above ("Zenith Angle"). Neither of these parameters affects channel balance in any meaningful or useable way.

Gross changes in Antiskating can sometimes affect channel balance, but measuring channel balance would be an ineffective method for adjusting that IME.

Azimuth angle (the angle the stylus makes relative to vertical when viewed from the front) effects inter-channel crosstalk. Many people, including me, have measured that to adjust azimuth and it's an effective method. Azimuth may also effect channel balance, but using that measurement to adjust azimuth would be far less precise than measuring crosstalk.

The other major cartridge setup parameters, VTF and VTA/SRA have no effect on channel balance that I'm aware of.

Doug

Azimuth alignment is what I meant to say. I have been adjusting the azimuth adjustment on my headshell seeing the impact on channel balance using the various test tracks on the Hi-FiNews Analogue Test LP. Sorry for my confusion.

Stringreen, thank you for the tip on the search, I found what I was looking for in this thread:

http://www.audioasylum.com/audio/vinyl/messages/74644.html

Dougdeacon, how do you measure crosstalk?

James1969, as Shure once had a record and meter that allowed you to adjust the channel outputs by changing Azimuth, so Denon once had a meter that allowed you to minimize crosstalk. I think I remember that you could also get a Denon product that reduced crosstalk. I have had and sold all of these and rely on my ears.