2. analog
  3. 1221123083

Correct belt size for Thorens TD 125 MK II

I need to purchase a new belt for my TD 125 MK II. It's in a repair shop right now, so I can't look at my old belt - it may have stretched, in any case, so I don't know if I could trust the measurement.

There are a few on-line sources for this, and most don't mention size, but two websites do, and they don't "agree" on size. Here are the two sizes I see:

20.0
21.2

So, just as having two clocks makes it harder to know the exact time, I find myself wondering how to be sure I will get the right belt. One of these retailers has it wrong.

I could try asking all the retailers, but I hope someone here can help me first. I looked trough the manual and service manual pages that I got off the Internet, but there is no mention of belt size there.

Hope someone can help!

-gritingrooves
gritingrooves
jaybo
4,478 posts
 
call needle doctor
kehut's avatar
kehut
668 posts
 
http://www.turntablebasics.com/belts/thorens.html

Contact Tim@turntablebasics.com
dekay's avatar
dekay
5,541 posts
 
I meant .2" which per my memory would be around 5 millemeters and/or .5 centimeters, please double check this.

I did a lazy "outside" measurement of the used belts (my bad), so take away a bit (the measurements S/B IC based).

This said, 21.2" would slip upon startup with minimul use, IMO.

Considering that your deck has already experienced stress/wear (pully replacement) I'll suggest you go with the upper range belt length mentioned (20.7").

I'll probably do the same the next time I purchase belts, even though the deck has low hours (considering its age of course).
gritingrooves OP
22 posts
 
Some burglars dropped it a long time ago. Who knows why the pulley is messed up. I really didn't pay attention to the speed problem till I started recording digitally.

The turntablebasics.com is where I see the 21.2 option (FM 21.2). I emailed Tim about an ordering question yesterday, and he hasn't answered yet.

I just got off the phone with someone at Needle Doctor. The guy said I need the "Thorens standard belt", which is "about" 20 inches.

So , that's interesting isn't it? Why does turntablebasics.com specify 21.2?

Needle Doctor wants about $25 for what they claim is an authentic Thorens belt. Turntablebasics wants only $10. Maybe it is a more generic one.

-gritingrooves
dekay's avatar
dekay
5,541 posts
 
The two belts measured are generic, but I don't recall the online vendor as they were purchased years ago.

I just did a WWW seach and see what you are up against (19.6" - 21.2" IC range).

I've used slightly wider belts in the past and though they cleared/played fine they dulled the sound a bit compared to the .2" version.

You received a reply @ the Thorens Forum, but I do not understand what the measurements/specs pertain to, even though I translated the page to English.

If you figure it out please post @ the Thorens Forum (just registered there and was not aware of it before).
More to discover