Help with uninspiring sound with my turntable.

Liketolisten,

I used to own the Wilson-Benesch Full Circle with the A.C.T. 2 tonearm, Sumiko Blackbird cartridge and Graham Slee Era V phono preamp and the sound was extremely clean and articulate. Sibilants had no distortion whatsoever.

I purchased that turntable new from Music Direct and they were kind enough to do the cartridge alignment for me.

I sold the table few years ago, but I still have the protractor that the table comes with. It is basically a disc with a mark point for the overhang and a single null point.

I highly recommend to get the Mint Tractor. You should also look into the Mint Tractor thread to get more information and tips on how to get the best out this amazing tool.

I have a PDF file of the manual, which I'll email to you. You'll be able to set the anti-skating with this manual, as well as the azimuth.

Thanks again for all the ideas - I am now able to enjoy listening to my vinyl. The issues were Tracking force, alignment, leveling surface that the TT was sitting on and stylus cleaning.

I am very grateful for Audiogon and its members - It has played such an important role in building my 2 channel system which I get so much enjoyment from.

Best regards,

Greg Roberts.

Good news! Glad it's sounding good now.

I can relate. I just worked through an issue with my turntable that some others have experienced similarly that could be a common thing worth mentioning in case it applies for you.

I was picking up a low level buzz/hum on my phono despite the fact that everything appeared grounded properly. I only noticed it recently after moving a larger pair of full range speakers into a relatively small listening room.

The problem was the pre-amp was sitting directly on top of a new amp that I had put in the system a few months back and the proximity of the amp was producing some sort of inductance issue with the phono section in the preamp.

I only noticed the problem when music was not playing and the volume was up, but I suspect it negatively impacted the sound quality when playing as well when occurring even though it was not directly audible.

The solution was to separate the amp from pre-amp by 15" or so.

Just something to keep in mind perhaps should a similar problem ever arise.

That is a very common problem...and one should always remember to keep the amp and preamp far from each other.