Graham Phantom Armwand


Does anyone know if the Phantom armwand that came with the 1st version is identical to the new Series 2 version. Connector end, internal wiring etc....
Any feedback appreciated. I may email Bob just to make sure.
Thanks
smoffatt
I bought both armwands in march not knowing there was a new model, so I didn't realise until recently when i had a failure with one of them that they where different. So I asked Bob and he answered me that the thinner (6mm diameter) is the new titanium. The older ceramic is 8 mm diameter.
Jloveys said, "Azimuth is more parallel with Titanium."

I don't see why you would think the arm wand material would make a difference with azimuth. The material would have nothing at all to do with proper azimuth. I'm sure the titanium wand is more susceptable to ringing than ceramic so it may not be as neutral as non-ringing ceramic, if that makes sense. In the end it does come down to which flavor you prefer which was already mentioned earlier in the thread.
Sorry, I was not clear, by azymuth I want to say that the headshell platform is parallel to bearing platform making magneglide markings in front of each other when azymuth is right. With the ceramic the marks are way out and main bearing is not straight.
"I have both the ceramic and titanium armwands. Having a hum issue with the ceramic, I tryed the titanium ... and it is totaly silent, more refined and precise."

I don't think a hum issue is related to whether the arm is ceramic or titanium.
I just glanced at this thread, and so thought I better set the record straight (no pun this time)... The titanium is a little smaller in diameter, and is even stiffer than the ceramic, but without the danger of breaking if dropped. This version of the armtube made it's way into Phantom "I" production, but just barely (maybe 20 or 30 units)...
The real Model II is identified by the "Phantom II" printed on the wand, and also includes a slightly revised headshell which gives better energy damping. Also, the new titanium tubes, being metal, serve as an electrical shield, something that the ceramic coudn't do.

And to answer "Frank sm" message, BOTH the ceramic and titanium tubes are damped, so ringing is not the reason for the clarity. It has to do entirely with increased stiffness and even BETTER damping in this design.

For the record (pun, this time): anyone who knows us or our design philosophy, knows we NEVER go for the exciting or thumpy just to get attention. Once the signal leaves the cartridge/tonearm, the die is cast, and no other amount of tweaking is going to cure brightness, whumpy bass, or a resonant-induced soundstage that is wider than was originally in the reacord groove. Neutrality, and freedom from ringing or other resonant nasties (however much they may grab your attention), is always the goal with us...